Ryobi TS1343L manual Cutting Warped Material, Clamping Wide Workpieces, See Figures 33, Wrong

OPERATION

Bevel
Angle		Type of Cut
Setting
	Left side, inside corner
33.85°	1.	Top edge of molding against fence
	2.	Miter table set right 31.62°
	3.	Save left end of cut
	Right side, inside corner
33.85°	1.	Bottom edge of molding against fence
	2.	Miter table set left 31.62°
	3.	Save left end of cut
	Left side, outside corner
33.85°	1.	Bottom edge of molding against fence
	2.	Miter table set left 31.62°
	3.	Save right end of cut
	Right side, outside corner
33.85°	1.	Top edge of molding against fence
	2.	Miter table set right 31.62°
	3.	Save right end of cut

CUTTING WARPED MATERIAL

See Figures 33 - 34.

When cutting warped material, always make sure it is posi- tioned on the miter table with the convex side against the fence as shown in figure 33.

If the warped material is positioned the wrong way as shown in figure 34, it will pinch the blade near the completion of the cut.

WRONG Fig. 34

WARNING:

To avoid a kickback and to avoid serious personal injury, never position the concave edge of bowed or warped material against the fence.

CLAMPING WIDE WORKPIECES

See Figure 35.

When cutting wide workpieces, such as 2 in. x 6 in., boards should be clamped with a C-clamp as shown in figure 35.

WIDE

BOARD

RIGHT Fig. 33

Fig. 35

26