Sanyo KHS1872 Using the Remote Control Unit, Temperature Display Selector, ACL button ALL Clear

Page 10

Remote Control Unit (continued)

SENSOR button

When you press this button (use a small-tipped object such as a ballpoint pen),

 

 

 

the

mark will appear at the display. And the room temperature is detected by

 

 

 

the sensor which is built into the indoor unit and the air conditioner is controlled

 

 

 

accordingly.

 

 

 

If the remote control is located near a heat source, such as a space heater or in

 

NOTE

 

 

 

 

direct sunlight, press the SENSOR button to switch to the sensor on the indoor

 

 

 

 

 

 

unit.

 

 

 

 

Temperature Display Selector

This switches the temperature display between °C and °F.

 

button

 

 

 

 

 

 

Time Display Selector button

This switches the time display between 24-hour time and 12-hour time.

 

 

 

 

ACL button (ALL CLEAR)

Puts the remote control unit into pre-operation status. Always press this button

 

 

 

after replacing the batteries.

 

 

 

 

ADDRESS switch

• The address switch changes to prevent mixing of signals from remote control

 

 

 

 

units when two air conditioners are installed next to each other. Normally, the

 

 

 

 

address switch is set to A. For more information, please contact the dealer

 

 

 

 

where you made the purchase.

 

 

 

• Normally, the tabs on the remote control unit should not be bent.

 

 

 

 

 

NOTE

The remote control unit sends the temperature signal to the air conditioner regularly at five minute intervals. If the signal from the remote control unit stops for more than 15 minutes due to the loss of the remote control unit or other trouble, the air conditioner will switch to the temperature sensor which is built into the indoor unit and control the room temperature. In these cases, the temperature around the remote control unit may differ from the temperature detected at the air conditioner’s position.

Using the Remote Control Unit

How to Install Batteries

1. Slide the cover in the direction indicated by the arrow and remove it.

2. Install two AAA alkaline batteries. Make sure the batteries point in the direction marked in the battery compartment.

3. Use a thin object such as the tip of a pen to press the ACL button.

ACL button

NOTE

The batteries last about six months, depending on how much you use the remote control unit. Replace the batteries when the remote control unit’s display fails to light, or when the remote control cannot be used to change the air conditioner’s settings.

Use two fresh leak-proof type-AAA alkaline batteries.

In replacing batteries, follow the instructions as mentioned in the sub- section “How to Install Batteries”.

If you do not use the remote control unit more than 1 month, take out the batteries.

10

OI-801-10-EG

 

Image 10
Contents Mode D’EMPLOI This air conditioner uses the new refrigerant R410AFeatures Alert Symbols ContentsProduct Information Safety Instructions Installation LocationElectrical Requirements Indoor Unit Names of PartsOutdoor Unit Unit Display and Operation Button Quiet lampRemote Control Unit Display Hour OFF Timer Remote Control UnitOn Time DRY AutoHeat CoolHow to Install Batteries Using the Remote Control UnitTemperature Display Selector Button Time Display Selector buttonUsing the Remote Control Unit Step Operation with the Remote Control UnitAutomatic Operation Press the ON/OFF operation buttonOperation with the Remote Control Unit Manual OperationAdjusting the Fan Speed Fan OnlyCooling and DRY Mode Night Setback ModeNight Setback Mode is used for saving energy High Power Mode Quiet ModeION Mode ‘‘DRY’’ Operation Remote Control UnitSpecial Remarks Heating OperationHow to set the present time Setting the TimerOperation Indication To cancel a timer program Press the Cancel button Setting the TimerRepeat timer 1030 pm 710 am 1100 am Present timeCancellation procedure Using the 1-Hour OFF TimerSetting procedure Operation together with the Daily ON/OFF Repeat TimerAdjusting the Airflow Direction Cool Sweep DRY FAN HeatCare and Cleaning Operation without the Remote Control UnitWhen the air conditioner is not running Care and Cleaning CleaningNegative ion generator metal electrodes inside plastic case Operating Range TroubleshootingTrouble Possible Cause Remedy Caractéristiques Table des matières Symboles d’avertissementInformations sur le produit Instructions relatives à l’alimentation Emplacement d’installationConseils de sécurité Élément Extérieur Nom des piècesÉlément Intérieur RemarqueAfficheur de l’appareil et bouton de fonctionnement Quiet TimerTimer OperationTélécommande Affichage Télécommande Télécommande suite On TIME/OFF TimeUtilisation de la télécommande Pour retirer la télécommande, tirer vers l’avant Utilisation de la télécommande suiteClimatiseur élément intérieur Récepteur Télécommande TrouFonctionnement automatique Fonctionnement avec télécommandeÉtape Fonctionnement manuel Fonctionnement avec télécommande suiteÉtape Remarque Vitesse automatique Réglage de la vitesse du ventilateurVentilateur uniquement Du ventilateurMode économie nocturne Ce mode permet de réduire la consommation d’énergieMode de fonctionnement Haute puissance Mode de silencieux QuietMode d’ionisation ION Fonctionnement séchage TélécommandeRemarques spéciales ChauffageActuelle Réglage du temporisateurRéglage à l’heure Réglage du moment de mise à l’arrêt OFF1030 p.m 710 a.m 1100 a.m Réglage du temporisateur suiteRéglage du moment de mise en marche on ProgrammationConseils pour économiser l’énergie HR. TimerEmploi du temporisateur 1 heure Daily ON/OFF RepeatRéglage du flux d’air Sweep Cool DRY FAN HeatElément Intérieur Fonctionnement sans télécommandeEntretien et nettoyage Si le climatiseur ne fonctionne pasEntretien et nettoyage suite FrontNettoyage du générateur d’ions négatifs Plage de températures de fonctionnement Guide de dépannagePanne Cause possible Remède Sanyo Fisher Company

KHS1872, KHS2472 specifications

The Sanyo KHS2472 and KHS1872 are two robust and efficient refrigeration solutions designed by Sanyo, a company reputed for its innovation in the appliances sector. Each model features advanced technology geared towards maximizing performance while providing energy efficiency, making them suitable for both commercial and residential use.

Starting with the Sanyo KHS2472, this model boasts a large capacity, making it perfect for businesses that require significant storage for perishable goods. The refrigeration system utilizes high-performance compressors that ensure rapid cooling and consistent temperature regulation. One of its standout features is the energy-efficient design, which contributes to lower electricity costs without compromising on effectiveness. The KHS2472 is equipped with multiple shelving options that enhance accessibility and organization, allowing users to store a variety of items without hassle.

In terms of technology, the KHS2472 integrates advanced temperature control mechanisms, including digital displays, that offer precise monitoring and adjustments. This ensures that the contents inside are stored at the optimal temperature while minimizing fluctuations. Furthermore, the model utilizes an eco-friendly refrigerant, aligning with Sanyo's commitment to sustainability and environmental responsibility.

On the other hand, the Sanyo KHS1872 is designed for those who require a slightly smaller capacity but still demand top-tier features and performance. This model is perfect for smaller establishments or as an additional refrigeration unit for larger operations. Similar to the KHS2472, the KHS1872 prioritizes energy efficiency, employing cutting-edge insulation technology that helps maintain temperature while reducing energy consumption.

The KHS1872 also comes equipped with user-friendly controls, allowing for easy temperature adjustments and monitoring. This model includes adjustable shelving as well, enabling efficient storage solutions tailored to various needs. Moreover, it features enhanced airflow systems that ensure uniform cooling throughout the storage area, preventing hot spots and ensuring optimal storage conditions.

Both models also include ergonomic designs with user-friendly access points, built with durability in mind to withstand the rigors of daily use. Easy maintenance features such as removable door seals and accessible interior components make routine cleaning simple. Overall, the Sanyo KHS2472 and KHS1872 exemplify quality engineering, catering to a diverse range of refrigeration requirements without sacrificing efficiency or performance.