Hilti WSC 55-A24, WSC 70-A36 operating instructions Hilti Corporation

Page 22

00_Cover_WSC70_A36_P1.qxd 1.6.2006 10:23 Seite 3

Hilti Corporation

LI-9494 Schaan Tel.: +423 / 234 21 11 Fax: +423 / 234 29 65 www.hilti.com

Hilti = registered trademark of Hilti Corp., Schaan W 3125 0606 00-Pos.1 1 Printed in Liechtenstein © 2006	236297 / A
Right of technical and programme changes reserved S. E. & O.

236297 236297

Image 22

Contents WSC 70-A36 WSC 55-A24 + +± ±#Ç 00CoverWSC70A36P1.qxd 2006 1023 Seite 00CoverWSC70A36P1.qxd 2006 1023 Seite Z54 General information ContentsSafety notices and their meaning Operating controls and partsExplanation of the pictograms and other information SymbolsDescription Obligation signsGrips SwitchesLiತion battery charge status Protective deviceAccessories Technical dataBattery 36/2.4 NiCd 36/3.3 Li-ion 24/2.0 NiCd Safety rulesPrAA Personal safety Power tool use and careService Never direct the power tool toward persons Work area Ensure that the workplace is well lit Battery use and careBefore use Personal protective equipmentOperation Adjusting the cutting angle Adjusting the riving knifeAdjusting the cutting depth Removing the saw bladeUsing the saw with a dust and chip removal system Fitting / adjusting the parallel guideUsing the saw on the guide rail Longitudinal cuts at Using the saw without a dust and chip removal systemCare of the NiCd battery Care and maintenanceCare of the power tool Care of the Li-ion batteryFault Possible cause Remedy TroubleshootingDisposal Manufacturer’s warranty tools EC declaration of conformity Hilti CorporationHilti Corporation