Makita BHS630 dimensions Blade Case Complete

Page 9

P 9/ 16

Repair

[3]DISASSEMBLY/ASSEMBLY

[3]-6. Blade Case Complete

DISASSEMBLING

(1)Remove Lever 55 and M6x85 Hex bolt as per the top right drawing in Fig. 5. Now the machine is free from Depth guide.

(2)Make the machine free from Angular guide as drawn in Fig. 8. Now the machine is separated from Base completely.

(3)Separate Blade case as per the upper left, upper right and lower left drawings in Fig. 10.

(4)Disassemble Safety cover and Gear section from Blade case as drawn in Fig. 12.

Fig. 12

1.Remove retaining ring WR-26 and Flat washer 26. Use 1R003 equipped with Claw of 1R212, when removing retaining ring WR-26.

<Note in Disassembling>

Hold the Retaining ring with your gloved hand so that it does not spring when removing.

2. Remove Safety cover, Tension spring 4 and Thickness ring.

Tension spring 4

Safety cover

Retaining

Flat washer 26

ring WR-26

 

3.Remove the parts of LED section, Rubber sleeve 6, M5-8 Hex socket

head set screw and M6 Hex nut.

LED section

 

4x20 Tapping screw

 

Cover

LED

Connector

Connector box

M6 Hex nut

M5-8 Hex socket head set screw

Thickness

4.Remove Bearing box (Gear section) by unscrewing four M4x16 pan head screws.

M4x16 Pan head screw (4pcs.)

Gear section

Gasket

Rubber sleeve 6

Image 9
Contents Specification Optional accessoriesStandard equipment Repair Necessary Repairing ToolsBase DISASSEMBLY/ASSEMBLYLock Lever Depth Guide Flat Washer 6 M6x85 Hex bolt LED and Motor Section Angular GuideNotch a Blade Case Complete DISASSEMBLY/ASSEMBLY Bearing Box Gear Section Lock Off Lever, Switch Lever Adjusting Accuracy of Parallel of Base to Saw blade Adjusting Accuracy of 90 degree cutFig. D-1 Circuit diagramWiring diagram Wiring of Brush holder’s Lead wiresWiring in Handle Connector box Wiring of LED Lead wires Blade case and Connector box