Makita BHS630 dimensions Wiring diagram, Wiring of Brush holder’s Lead wires, Wiring in Handle

Page 15

P 15/ 16

Wiring diagram

Fig. D-2

Wiring of Brush holder’s Lead wires

Fix Brush holder’s Lead wires in Lead wire holders.

Lead wire holder

Brush holder

Opening for Lead wires

Brush holder

to ON/OFF Switch in Handle

Pass the Lead wires through the opening to Blade case side.

Fig. D-3

Wiring in Handle

Fix the following Lead wires in these Lead wire holders.

*Lead wre (white) between ON/OFF switch and Switch unit of LED

*Lead wire (black) between Controller and Connector

Lead wire holder

Lead wire holder

Put Lead wires for

Connector

connecting to Connector

inside the Rib.

 

See Fig. D-4 in the next page.

Fix Lead wires (black), (white) of Brush holders in

 

 

Lead wire holder here so as not to make any slacks

 

 

 

Opening for Lead wire

between Opening and the lead holder.

 

 

 

 

Image 15
Contents Specification Optional accessoriesStandard equipment Repair Necessary Repairing ToolsBase DISASSEMBLY/ASSEMBLYLock Lever Depth Guide Flat Washer 6 M6x85 Hex bolt LED and Motor Section Angular GuideNotch a Blade Case Complete DISASSEMBLY/ASSEMBLY Bearing Box Gear Section Lock Off Lever, Switch Lever Adjusting Accuracy of Parallel of Base to Saw blade Adjusting Accuracy of 90 degree cutFig. D-1 Circuit diagramWiring diagram Wiring of Brush holder’s Lead wiresWiring in Handle Connector box Wiring of LED Lead wires Blade case and Connector box