OPERATION
ANGLE CUTTING (Bevel Cutting)
See Figures 11-12, page 11.
Bevel cutting angles may be adjusted from 0° to 45° right or left. Angles for cuts from 0° to 45° in 15° increments are marked on a scale on both the left and right side of the base. Notches on the underside of the base provide positive stops at each of the above mentioned 15° increments. A protractor is recommended when accurate cuts are required.
Remove the battery pack.
Remove the hex key from the storage compartment. Loosen the two base pivot screws until the base can be moved.
NOTE: Do not completely remove screws.
Slide the base backward until the base can move freely left and right.
Align the pointer on the housing with the desired angle indicated on the scale on the saw base.
Once the desired angle is reached, slide base forward until the tab on the motor housing aligns with the appropriate notch on the underside of the base.
NOTE: When making a
Tighten the base pivot screws securely.
Return the hex key to the storage compartment.
Replace the battery pack.
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts. Use of any other parts could create a hazard or cause product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
ACCESSORIES |
|
Look for these accessories where you purchased this product or call |
|
Edge Guide Kit | 202936001 |
WARNING:
Current attachments and accessories available for use with this product are listed above. Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury.
This product has a Three-year Limited Warranty.
For Warranty details go to www.ryobitools.com
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 9
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
8 - English