Harbor Freight Tools 96526 operating instructions To Operate The Torque Selector, See Figure D

3.Hold the Keyless Chuck (1) firmly while turning the forward section of the Chuck counterclockwise. This opens the Chuck to accept the drill or screw driver bit.

(See Figure D.)

4.Continue turning the Keyless Chuck (1) counterclockwise until the drill bit or screw driver slips into the Chuck Jaws. (See Figure D.)

KEYLESS CHUCK (1)

FORWARD SECTION

DRILL BIT

(NOT INCLUDED)

FIGURE D

5.Turn the forward section of the Keyless Chuck (1) clockwise while holding the

Chuck firmly in place to tighten the Chuck around the drill bit or screw driver shaft. Make sure the drill bit or screw driver is seated securely before operation.

(See Figure D.)

6.Push the Forward/Reverse Switch (7) to the right. Gently press the Power Switch and note whether the bit wobbles while it rotates. If the bit wobbles, release the power switch, repeat steps 1 through 5 to reposition bit.

To Operate The Torque Selector

1.The Torque Setting Ring (3) is a 19-position dial located behind the Keyless Chuck (1). The Torque Setting Ring also features one drill setting.

(See Figure D.)

TORQUE SETTING RING (3)

FIGURE E

SKU 96526 For technical questions, please call 1-800-444-3353. Page 12