faster the Battery loses power. A Battery that gets too hot can be permanently damaged. Never
to diminish, stop the tool, recharge the Battery and use the fresh Battery for optimal performance.
•Place the Battery (29) into the Charger Stand (23) as described in the section “To Charge The Battery”. The charging room temperature should be between 50° Fahrenheit and 104° Fahrenheit.
•If the Battery (29) has charged from 3 to 5 hours but will not power the Drill/ Driver, the Battery may need replacement. Purchase replacement batteries only from Harbor Freight Tools. Do not attempt to repair the Battery.
•Contact local hazardous waste disposal authorities for proper Battery disposal. Never set fire to a used Battery.
•Keep the Drill/Driver exterior free of oil and grease. Use only a mild detergent and damp cloth when cleaning. Do not use a flammable or combustible solvent. Do not immerse this tool in a liquid or allow a liquid to flow inside the tool.
4.WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.
5.CAUTION! All maintenance, service, and repairs not mentioned in this manual must only be performed by a qualified service technician.
Troubleshooting
Problem |
| Possible Causes |
| Possible Solutions |
Drill/Driver will not | 1. | Battery not connected properly. | 1. | Properly connect Battery. |
start. | 2. | Low Battery. | 2. | Recharge Battery from |
| 3. | Defective Battery. | 3. | Replace Battery. |
Unsatisfactory drilling | 1. | Dull drill bit. | 1. | Use sharp drill bit. |
results. | 2. | Drill bit improperly installed in | 2. | Make sure drill bit is securely |
|
| Chuck. |
| installed in Chuck. |
| 3. | Improper drilling technique. | 3. | See “Drilling An Object” section. |
SKU 96526 | For technical questions, please call | Page 15 |