WARNING: Always use eye protection. All users and bystanders must wear eye protection that conforms to ANSI Z87.1.
Side Handle (Fig. 1)
WARNING: To reduce the risk of
•The label on your tool may include the following symbols. The symbols and their definitions are as follows:
V | volts | A | amperes | ||||
Hz | hertz | W | watts | ||||
min | minutes |
|
|
| ....... alternating current | ||
|
|
| ...direct current |
|
|
| alternating or direct current |
|
|
| no | ||||
|
|
| Class I Construction | no load speed | |||
|
|
| |||||
|
| ........ | |||||
|
|
| (grounded) |
|
|
| earthing terminal |
|
|
|
|
|
| ||
............ |
|
|
|
| ........ | ||
|
| ........ | Class II Construction |
|
| ......... | safety alert symbol |
personal injury, ALWAYS operate the tool with the side handle properly installed. Failure to do so may result in the side handle slipping during tool operation and subsequent loss of control. Hold tool with both hands to maximize control.
A side handle is supplied with this hammerdrill. It clamps to the front of the gear case as shown in Figure 1
FIG. 1
............ | (double insulated) | BPM .... | beats per minute |
…/min .per minute | RPM .... | revolutions per minute | |
IPM | impacts per minute | sfpm .... | surface feet per minute |
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of injury, turn unit off and disconnect tool from power source before installing and removing accessories, before making any adjustments or removing/installing attachments or accessories. An accidental
and can be rotated 360˚ for right- or left- hand use.
Switch (Fig. 2)
WARNING: Be sure to release the locking mechanism before disconnecting the plug from the power supply. Failure to do so will cause the hammerdrill to start immediately the next time it is plugged in. Damage or personal injury could result.
To start hammerdrill, depress the trigger switch. To stop hammerdrill, release the trigger switch.
To lock the trigger switch in the ON position for continuous operation, depress the trigger switch and push up the locking button. The tool will continue to run. To turn the tool OFF, from a
DO NOT lock the switch on when drilling by hand so that you can instantly release the trigger switch if the bit binds in the hole. The locking button is for use ONLY when the hammerdrill is mounted in a drill press stand or other wise held stationary.
English
15