Polycom Version 2.0.3B manual Dial Plan in Application Configuration File, Local

Technical Bulletin

SoundPoint ® IP, SIP 2.1

Local	Web Server	Specify impossible match behavior, trailing # behavior,
	(if enabled)	digit map matching strings, and time out value.
		Navigate to: http://<phoneIPAddress>/appConf.htm#ls
		Changes are saved to local flash and backed up to
		<Ethernet address>-phone.cfgon the boot server.
		Changes will permanently override global settings unless
		deleted through the Reset Local Config menu selection.

Dial Plan in Application Configuration File

The <dialplan/> attribute is described below and also includes:

•Digit Map <digitmap/> on page 3.

Note	The dial plan is not applied against Placed Call List, VoiceMail, last call return, and
	remote control dialed numbers.

This configuration attribute is defined as follows:

Attribute	Permitted	Default	Interpretation
	Values
dialplan.applyToCallListDial	0, 1	0	This attribute covers dialing from
			Received Call List and Missed Call List
			including dialing from Edit or Info sub-
			menus.
			If set to 0, the dial plan is not applied
			against the dialed number.
			if set to 1, the dial plan is applied
			against the dialed number.
dialplan.applyToDirectoryDial	0, 1	0	This attribute covers dialing from
			Directory as well as Speed Dial List.
			Value interpretation is the same as for
			dialplan.applyToCallListDial.
			Note: An Auto Call Contact number is
			considered a dial from directory.
dialplan.applyToUserDial	0, 1	1	This attribute covers the case when the
			user presses the Dial soft key to send
			dialed number when in idle state
			display.
			Value interpretation is the same as for
			dialplan.applyToCallListDial.

2