Polycom Version 2.0.3B manual Billing Code Entry

Page 30

Technical Bulletin 9268

Billing Code Entry on SoundPoint® IP Phones with Sylantro

This technical bulletin provides detailed information on how the SIP application has been modified for billing code entry when managed by a Sylantro call server.

This information applies to SoundPoint IP phones running SIP application version 2.1 or later.

Introduction

Note	This feature is only supported on Sylantro call servers.

Billing codes let administrators assign specific codes to all of their organization’s outgoing calls.

When a SoundPoint IP phone managed by a Sylantro call server is configured to require billing codes, calls are not connected until the a valid billing code is entered.

The modified user interface on a SoundPoint IP phone running SIP 2.1 is described in the following section, Billing Code Entry.

Billing Code Entry

This section describes the steps the user must perform to enter a billing code.

To enter a billing code when placing a call:

1.Do one of the following to a place a call:

a With the handset on-hook, enter the long-distance number (including prefix).

You may need to press the Dial soft key to indicate you are finished entering the number.

bPick up the handset and enter the long-distance number (including prefix).

<December, 2006> 3725-17483-001/A

Image 30

Contents SIP 2.0 Administrator’s Guide SoundPoint/SoundStation IP SIP Polycom, Inc Configurable Feature Keys Attribute DefaultHandset, Headset, and Speakerphone Attribute Permitted Default Interpretation Values LCD BacklightPermitted Attribute Values Default Interpretation DefaultExpanded Memory and Expanded Flash Memory RAM Disk ramdisk Default Interpretation MicroBrowserPermitted Values 6 G.722 Audio Codec Attribute ValuesAttribute Default Receive rxEq USB Diagnostics Administrator’s Guide SoundPoint IP / SoundStation IP Digit Map Billing CodeSyslog Server Redundancy Supported Platforms Unsupported PlatformsDisable Message Waiting Indicator by Registration Daylight Saving Time Changes forDST Platform Key IDs Miscellaneous Configuration File Changes 9.1 sip.cfgPorted on SoundPoint IP Attribute Permitted Default Interpretation Values Phone1.cfg Device Parameter Introduction Configuration File ChangesBoot server Sip.cfg CentralDial Plan in Application Configuration File Attribute Permitted Default Interpretation ValuesLocal Permitted Attribute Values Default Interpretation Dial Plan in Per-Phone Configuration File Attribute Permitted Values Default InterpretationDial Plan in Application To Digit Map digitmap/ on Trademark Information Dialplan.x.digitmap isBilling Code Entry Billing Code Entry on SoundPoint IP Phones with SylantroTrademark Information Syslog on SoundPoint IP Phones Network Configuration Changes Name Possible Values DescriptionFlash Parameter Configuration Name Possible Values DescriptionSIP Server Fallback Enhancements on SoundPoint IP Phones SIP 2.0 Administrators Guide TerminologySIP 2.1 Server Fallback Implementation Example DeploymentReg.1.server.2.address=172.23.0.1 Behavior When the Primary Server Connection Fails Recommended Practices for Server Fallback Deployments Changes From Previous Phone Behavior Releases Before SIPBefore SIP Protocol in Application Configuration File Boot serverRegistration in Per-Phone Configuration File References Trademark Information