Bose Complete Wiring Instructions for CC-16 Sound System Zone Controller

Page 11

Wiring

Connecting the wires

The CC-16 zone controller uses a standard 6-wire Eurostyle terminal block for power and network connections.

1.Connect the network cable to the RS-485 A/B pins on the ESP-88. Note which wire is connected to A and B.

2.Connect the network cable to the CC-16 terminal blocks. Ensure the wire connected to “A” on the ESP-88 is the same one connected to “A” on the controllers and that the “B-wire” is connected to “B” on the controllers. Connect Shield to the RS-485 cable shield if necessary.

3.Connect the power supply to the Ground and Vin+ terminals on the controllers.

Wiring Example

Image 11

Contents ControlSpace CC-16 Zone Controller For the intended audience Important Safety InstructionsInformation about products that generate electrical noise Regulatory information Please read this install guideIntroduction Features and functionsQuick start Cabling InstallationMaximum cable distances Installing the mounting boxDIP switch addresses DIP Switch SettingsTermination Connecting the wires WiringPower supply WiringMounting the CC-16 zone controller MountingTroubleshooting Specifications Bose Product Sales Conditions WarrantyOther Rights Page