Introduction
Quick start
1.Run power and network (2-wire) cables from the ESP-88 to the CC-16 mounting location and install a mounting box.
2.Set the DIP switches to define the unit address and termination (see silkscreen on back of CC-16).
3.Connect the power and network wires to the CC-16’s terminal block and insert unit into the mounting box.
4.At the ESP-88, connect the network wire to the RS-485 port and connect the power cable to a power source.
5.Run the ControlSpace® Designer software to configure and test. The CC-16 must be connected to an ESP and configured with the ControlSpace Designer software before it can be used. Please refer to the Designer User’s Guide for complete details on configuring and programming the CC-16 in a ControlSpace system.
CAUTION: The building code may require professional installation by a skilled technician or licensed contractor.
