Bose manual Mounting the CC-16 zone controller

Page 13

Mounting

Mounting the CC-16 zone controller

Warning: The CC-16 must be installed in a National Electric Code (NEC) approved, enclosed electrical wall box.

After setting the DIP switches and connecting the wires, mount the CC-16 zone controller in the electrical box. Two sets of screws are provided. Use the screws that are appropriate for your wall-box – the #6 for North American boxes, and the M4 for Japanese, European and Australian boxes.

CAUTION: Do not overtighten the screws. Overtightening may cause the frame to break.

Mounting the CC-16 Zone Controller in a North American 2-gang wall box

After screwing the frame into the wall box, remove the protective clear film and snap on the cover. The cover can be removed later using a small flathead screwdriver in the slots on the sides.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents ControlSpace CC-16 Zone Controller For the intended audience Important Safety InstructionsInformation about products that generate electrical noise Regulatory information Please read this install guideIntroduction Features and functionsQuick start Cabling InstallationMaximum cable distances Installing the mounting boxDIP switch addresses DIP Switch SettingsTermination Connecting the wires WiringPower supply WiringMounting the CC-16 zone controller MountingTroubleshooting Specifications Bose Product Sales Conditions WarrantyOther Rights Page
Top Page Image Contents