EN Installation

Installation

Installation procedure for users of Windows® XP & 2000

To properly install your SGC2910 Wireless PC Controller, the controller must be connected to your USB port first. Once Windows XP and 2000 have properly loaded the HID (human interface device) drivers for the SGC2910 you can begin software installation.. Carefully follow the steps below..

Installation procedure for users of Windows® 98SE & ME

Installation step for Windows 98SE and ME is the same as the Windows XP and 2000.. However, you will need to install the software first and once finished, you can plug in the controller. Please perform the installation in this order to ensure the SGC2910 and software is installed properly.. Carefully follow the steps below in the correct order..

Note: If you are connecting a USB device for the first time,Windows 98SE and ME may ask for the Windows Setup CD-ROM during installation to install the required system files.You will need to place the Windows Setup CD-ROM in your CD-ROM drive to finish the installation.

Controller Setup and Installation

1.Make sure the SGC2910 Wireless PC Controller on/off switch is in the off position.. Remove the battery cover and install three (3) AAA batteries into the SGC2910 Wireless PC Controller (not included).. Plug the USB docking receiver into an available USB port on the PC.. (Plug directly to a USB port on your PC tower or desktop..)

2.Windows 98SE, ME, 2000, and XP will automatically detect the SGC2910 Wireless PC Controller upon connection..The Wireless PC Controller will be detected by Windows as “SGC2910 Wireless PC Controller”..

3.In Windows 98SE and ME, a Windows message will announce “NEW HARDWARE FOUND”..The ADD NEW HARDWARE WIZARD will open announcing that Windows has detected a USB Human Interface Device.. Click ‘NEXT’ to continue..Windows will ask,“What do you want Windows to do?” Choose the default option:“Search for the best driver for your device”..Then click ‘NEXT’.. Follow the onscreen instructions to allow Windows to install the recommended HID drivers for your device.. (NOTE: If you are connecting a USB device for the first time,Windows may ask for the Windows Setup CD-ROM during installation to install the required system files.)

4.In Windows XP and 2000, a Windows message will announce that “NEW HARDWARE FOUND”, followed by another message announcing “Human Interface Device Found”..Windows will then automatically load the correct HID drivers for the Wireless PC Controller..

5.Once installation has completed,Windows may prompt you to restart your PC.. If this occurs please select ‘YES’..

Note: LED on the docking receiver flashes when scanning for the SGC2910 Wireless PC Controller and stays illuminated when connection is complete.. RF connect button on controller will stay illuminated continuously while the SGC2910 Wireless PC Controller on/off switch is on..

Software Installation for Users of Windows®

1.The SGC2910 Wireless PC Controller should be connected to your PC before beginning software installation under Windows XP and 2000. In Windows 98SE and ME the software is installed first.

2.Close down all programs that are currently running on your computer..

3.Place the SGC2910 software CD into your CD-ROM drive..

4.Click on the ‘START’ button in the Windows Task Bar and choose ‘RUN’.. Click ‘BROWSE’ and choose your CD-ROM drive..The ‘LOOK IN’ box should display your CD-ROM drive.. NOTE:You may need to click on the ‘My Computer’ icon in order to select your CD-ROM drive..