Lexicon DC-1 owner manual Troubleshooting, Problem

Page 71

DC-1 Digital Controller

Troubleshooting 4 Troubleshooting

If you encounter a problem, please review the items in the following

Troubleshooting

checklist. Also be sure to thoroughly check all other connected components

 

 

such as speakers, receiver/amplifier/preamp, VCR, TV, CD player, etc.

 

Problem

Possible Cause and Solution

Power does not come on

No audio

Remote control not working

No output

Center Channel only plays

Muffled sound in L&R channels

Center channel sound muffled

No Input Level Meters

Check line cord to ensure good connection to the AC outlet and to the receptacle on the DC-1 rear panel. Check to make sure that the DC-1 rear panel power switch is ON.

Check input and output connections. They may be reversed relative to the IN and OUT jacks of your receiver/amplifier/preamp or other source.

Check batteries to be certain that they are inserted correctly with proper polarity. Make sure that the infrared sensor on the DC-1 front panel is not obstructed. See "If all else fails..." on the following page.

Make sure that signal is coming into the DC-1. Increase VOLUME using the remote control and check Front/Back and Left/Right BALANCE.

Check the DC-1 MUTE controls to make sure they are not engaged.

Check all other equipment settings and connections and verify that the amplifiers being fed by the DC-1 are operational.

Remember that the DC-1 mutes the output to any speakers which are not configured in the Setup menu. If speakers are added to (or removed from) your system, the Speaker Configuration menu must be altered accordingly.

Check to see if your HiFi VCR has dropped out of tracking — readjust.

Your VCR Stereo/Mono/L-R switch may be in the wrong position — set it to Stereo.

When no center channel is used, CENTER must be configured for NONE in the Setup Speaker Configuration menu.

The center channel amp may be connected to the subwoofer jack on the DC-1 rear panel. Reconnect to Center Output jack.

The meters will only appear when adjusting the Gain parameter of a selected, active input.

65

Image 71
Contents DC-1 Acknowledgements Important Safety InstructionsCommunications Notice Vigtig information om sikkerhed Wichtige Sicherheitsanweisungen DC-1 Contents Contents, contd Introduction Introduction to the DC-1 About Dolby Digital AC-3 encoding Introduction to the DC-1 Unpacking and Inspection Using the Documentation Glossary of Terms DC-1 Block Diagram Display Controls IndicatorsFront Panel ZONE2 and Record Power On/OffRear Panel Menu Remote ControlOFF and on MuteSignment Cleared Remote Control Accy FunctionsLocation Considerations AC Connections ConnectionLength AWG Size Wiring ConsiderationsWire Lengths Audio/Video ConnectionsConnecting DC-1 as a preamp Installation Calibration LD/DVD Players AC-3 Ready Laser DiscRECORD/ZONE 2 Operation Zone 2 Remote Control Zone 2 IR Remote Mode EnabledExclusive Zone 2 Control System Configuration Video Input Selection On-Screen Display Video On-Screen DisplayInput Gain System SetupInput Name Restore Input Name Effect Non AC-3 Effect BaseDolby Digital Digital Audio Input Assignment Center Setting the Speaker ConfigurationFront L/R Subwoofer Output Setting Output Levels Subwoofer Peak Limiter Dolby Digital versionMute Level Power On Volume Zone 2 Volume Time Alignment Dolby Digital version Setting Listener PositionBase and THX versions Center DelayCalibrate Panorama Installation Calibration Settings are Locked Bass and Treble Level Equalization THX and Dolby Digital versionsTilt Dolby Digital version Customizing Effects DC-1 EffectsDC-1 Effects Music Surround Parameters Music Surround THX and Dolby Digital versionsParameter Initial Value Range Pro Logic ParametersTHX Cinema Parameters THX Cinema THX and Dolby Digital versionsLogic 7 Parameters Logic 7 THX and Dolby Digital versionsDC-1Effects TV Matrix Parameters TV MatrixDC-1Effects Mono Logic Parameters Panorama Parameters PanoramaDC-1 Effects Nightclub Parameters NightclubConcert Hall Parameters Concert HallChurch Parameters ChurchCathedral Parameters CathedralMusic Logic Parameters Music LogicDC-1 Effects Party Parameters PartyTwo Channel Two Channel ParametersAC-3 Status Display Dolby Digital version Music Parameters Music Dolby DigitalDolby Digital Parameters Dolby Digital Dolby Digital versionTHX 5.1 Parameters THX Dolby Digital versionLogic 7 Dolby Digital version DC-1Effects 1Two Channel Dolby Digital version Problem TroubleshootingProblem Possible Cause and Solution TroubleshootingRoutine Maintenance Restoring Defaults TroubleshootingSpecifications Listener Position Panorama Speaker Configuration circle selectionOSD Position Display TimeLexicon, Inc Oak Park