My modules will not respond to my controller.
Make sure that the HouseCode on all Modules and Controllers are set to the same HouseCode (A .. P).
My modules will not react to my remote / sensor.
When you use a remote or sensor, you should have at least one TM13 Transceiver or Marmitek Security Console installed in your house. These components will translate the radio signals to the Marmitek
Am I able to increase the range of my remotes by using more Transceivers?
Yes, you can use more than one TM13 Transceiver in your home when the range of your remotes is not sufficient. The TM13 is using so called collision detection to prevent signals to be disturbed when more than one TM13 is transmitting. TM13’s will wait for a quite power line before transmitting their data. To prevent your Marmitek
The IRRF7243 does not work with my remote control.
The house code of both the remote control and the rest of the components must have the same letter code. Take care that your Marmitek remote control is installed for use with the IRRF7243. The correct code is to find in the code book of your remote control.
My IRRF7243 commands the wrong units.
Is the switch (
Which remote controls can I use with the IRRF7243 ?
The following remote controls can be used with the IRRF7243:
Infrared remotes:
•Marmitek 4in1
•Marmitek 6in1
•Marmitek EasyControl4
10 | © MARMITEK |