Sharp KC-860U Water Supply Indicator Light, Sound indicator setting for water supply

Page 16

OPERATION

LIGHTS CONTROL Button

Use when the light on the front panel is too bright.

Refer to the diagram to select the desired brightness on the front panel.

｢

 

｣

 

 

 

 

The lights on the front panel are brighter.

｢

 

｣

 

The lights on the front panel are darker.

 

 

｢

 

｣

 

The lights on the front monitor turn off.

 

 

 

 

 

CAUTION The lights on the front monitor are always brighter when starting.

WATER SUPPLY INDICATOR LIGHT

When the Water Tank is empty, the Water Supply Indicator Light will flash to indicate that the Water Tank should be refilled. Please note the light will not flash even when the Water Tank is empty during the Clean Air Mode and the Quick Clean Mode.

Sound indicator setting for water supply.

In addition to the Indicator Light, the unit can be set to signal with an audible beep when the Water Tank is empty. With the unit OFF, press the Lights Control button for 3 seconds to turn the audible signal ON.

Cancellation

To cancel the audible signal, with the unit OFF, press the Lights

Control button again more than 3 seconds.

ADJUSTMENT OF SENSOR DETECTION SENSITIVITY

Set to ‘low” if the DUST MONITOR is constantly red to reduce sensitivity, and set to ‘high’ if the DUST MONITOR is constantly green to increase sensitivity.

1 With the unit OFF, press the Fan Speed Button for 3 seconds.

The Fan Speed Indicator Lights will display the currently set sensor sensitivity level. The factory setting is Standard, indicated by the MED light.

2 Press the Fan Speed Button to set the desired sensor sensitivity.

Refer to the diagram on the right to select the desired sensor sensitivity level.

3 Press the Power OFF Button.

Note that if the Power OFF Button is not pushed within 8 seconds of adjusting sensor sensitivity, the setting will be saved automatically. The sen- sor sensitivity setting will be saved even if the unit is unplugged.

Fan Speed

Sensor Detection

Indicator Light

sensitivity

 

High

 

Standard

 

Low

E-14

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Manuel D’UTILISATION Purificador DE Aire AIR PurifierManual DE Operación Please read before operating your new Air Purifier English For Customer Assistance the United States Consumer Limited Warranty Consumer Limited Warranty for U.S. UsersFor Customer Assistance Canada Limited Warranty Important Safety Instructions Filter Guidelines Installation GuidelinesPlace on a stable surface with sufficient air circulation Illustrative Diagram Front Back Part NamesHandle2 locations left and right Sensors Rating LabelFront Monitor Main Unit DisplayDust Monitor Filter Installation Install the True Hepa filterRefilling the Water Tank Clean AIR & Humidify Mode Clean AIR ModePress the Clean AIR Mode Button on the display About Automatic Humidify ModePollen mode operation Quick Clean ModeMAX operation Medium operation LOW operation Water Supply Indicator Light Sound indicator setting for water supplyPress the Power OFF Button With the unit OFF, press the Fan Speed Button for 3 secondsCare and Maintenance UnitWashable Deodorizing Filter Care Water TankReplace the filter in unit. See E-10 Humidifying Tray Rinse the Humidifying Tray with lukewarm waterHumidifying Filter Remove the Water Tank and Humidifying TrayRemove the Humidifying filter From the Humidifying Tray Preparingtion. the descaling soluWashable Deodorizing filter Up to 5 years after opening Filter Replacement GuidelinesHumidifying filter Troubleshooting SymptomLamp Indication Error Details Remedy Flashing of the Clean AirHumidify Indicator Light Flashing of the Quick CleanSpecifications Standby PowerEnglish Page Capte LA Poussière Atténue LES OdeursRafraîchit HumidifiePour Vous Protéger Pour Téléphoner Composez le 1-905-568-7140 pourGarantie Limitée Instructions DE Sécurité Importantes Guide D’INSTALLATION Précautions Concernant LE FonctionnementGuide D’UTILISATION DES Filtres Ne nettoyez l’extérieur qu’avec un chiffon douxPoignée 2 emplacements, gauche et droit Capteurs Désignation DES PiècesSchéma Illustratif Avant DOS DE L’APPAREILAffichage DE L’UNITÉ Principale Moniteur AvantMoniteur DE Poussière Lampe témoin du Plasmacluster bleueInstallation DES Filtres Installez le filtre Hepa authentiqueRemplissage DU Réservoir D’EAU Après le remplissage, serrez bien le bouChon du réservoir Replacez le réservoir d’eau dans l’appareilMode D’ÉPURATION DE L’AIR Propos du mode d’humidification automatiqueBouton de vitesse du Bouton de Mode FonctionnementMode D’ÉPURATION Rapide Fonctionnement en mode PollenFonctionnement Maximum Fonctionnement MoyenLampe D’ALIMENTATION EN EAU Réglage d’indicateur sonore de l’alimentation en eauAnnulation Appuyezl’appareil. sur le bouton d’arrêt dePanneau Arrière ET Capteurs Soin ET EntretienAppareil Réservoir D’EAU Cycle d’entretien Chaque jour en cas d’humidificationBAC D’HUMIDIFICATION La fréquence du cycle d’entretien dépend de la dureté de l’Mois Toyez le bacRetirez le réservoir d’eau et le bac d’humidification Filtre D’HUMIDIFICATIONRetirez le filtre d’humidification du bac d’humidification Guide DE Remplacement DES Filtres Guide de remplacement des filtresRésolution DES Problèmes SymptômeAffichage Lumineux Origine Solution DE L’ERREURCaractéristiques Consommation en veilleFrançais Lea antes de operar su nuevo Purificador de aire Atrapa EL Polvo Disminuye LOS OloresReduce EL Polen Y Moho RefrescaInstrucciones DE Seguridad Importantes Pautas Para LA Instalación Precauciones Relacionadas CON LA OperaciónPautas Para EL Filtro Diagrama Ilustrativo Parte Frontal Nombre DE LAS PartesParte Posterior Manija 2 ubicadas a la derecha e izquierda SensoresMonitor Frontal Pantalla DE LA Unidad PrincipalMonitor DE Polvo Instale el filtro Hepa Instalación DEL FiltroAsegurarlas superiores en su lugar Llenado DEL Tanque DE Agua Después de llenar, apriete bien la tapa delTanque Reemplace el tanque de agua en la unidadPresione el botón Modo Clean AIR Aire Limpio en la pantalla Modo Clean AIR Aire LimpioSobre el Modo Automatic Humidify Humidificador automático Modo Quick Clean Limpieza Rápida Operación MáximaOperación Media Operación BajaCancelación OperaciónCuidado Y Mantenimiento UnidadLimpie y seque con un paño suave No use fluidos volátilesReemplazo del filtro en la unidad. Vea S-6 Tanque DE AguaCiclo de cuidado a diario cuando use el humidificador Humidificador Bandeja DEL HumidificadorEnjuague la bandeja del humidificador con agua templada Filtro DEL Humidificador Retire el tanque de agua y la bandeja del humidificadorTenga cuidado de no derramar agua cuando limpie el filtro Para usar ácido cítricoPautas Para Reemplazar EL Filtro Filtro del humidificadorFiltro True Hepa Hasta 5 años después de abrirlo Hasta 2 años después de abrirloLocalización DE Fallas SíntomaSeñal Luminosa Detalles DE Error Solución Especificaciones Energía de reservaEspañol Osaka, Japan New Jersey 07495-1163 U.S.A Ontario L4Z 1W9 CanadaSharp Plaza, Mahwah Britannia Road East Mississauga

KC-860U specifications

The Sharp KC-860U is an innovative air purifier and humidifier designed to provide a healthier living environment. This multifunctional device combines advanced air cleaning technologies with humidification capabilities, making it particularly beneficial for households seeking to enhance air quality and comfort.

One of the standout features of the KC-860U is its unique Plasmacluster technology. This patented system releases positive and negative ions into the air, which work to neutralize airborne pollutants, including bacteria, viruses, mold spores, and allergens. The Plasmacluster ions essentially mimic the purification process that occurs in nature, creating a fresher atmosphere inside your home.

Another key characteristic of the KC-860U is its HEPA filter. This filter captures at least 99.97% of particles that are as small as 0.3 microns, including dust, pollen, pet dander, and smoke. The combination of HEPA filtration and Plasmacluster technology ensures that harmful substances are effectively removed from the air, providing you with peace of mind that your indoor environment is safe and clean.

The device is also equipped with an activated carbon filter that effectively absorbs odors and volatile organic compounds (VOCs). This feature is particularly useful in kitchens or areas with pets, as it helps to eliminate unwanted smells and chemicals from the air.

In terms of humidity control, the KC-860U boasts a built-in humidifier that adds moisture to dry air, improving overall air quality. This is especially important in winter months or arid climates where low humidity can lead to discomfort, dry skin, and respiratory issues. The humidifier operates quietly, allowing for seamless integration into daily life without disturbing your peace.

The KC-860U is designed for convenience and ease of use. It features a user-friendly interface with intuitive controls, allowing you to adjust settings effortlessly. Additionally, it includes a filter replacement indicator, ensuring that you are always aware of when maintenance is required.

With its sleek design, the Sharp KC-860U is not just functional but also complements modern home aesthetics. It operates efficiently and is suitable for medium to large-sized rooms, making it a versatile choice for various living spaces.

In summary, the Sharp KC-860U stands out as a robust air purification and humidification solution, combining advanced Plasmacluster ion technology, HEPA filtration, and an effective humidifier. Whether you are combating allergens or simply seeking a fresher environment, this device delivers high performance and comfort in one sleek package.
Top Page Image Contents