Sharp KC-860U operation manual Rinse the Humidifying Tray with lukewarm water

Page 19
Insert the tab of the float into the hole.

HUMIDIFYING TRAY

 

 

Frequency of maintenance cycle will depend on the hardness

Care Cycle

1 month

of the water. Avoid spilling water when removing or cleaning

 

 

the tray.

1

Remove the Water Tank and Humidifying Tray.

Unlatch the Water

 

 

Tank first, then re-

Tank Handle

 

move the tray. Use

 

both hands when

 

 

pulling out the

 

 

Humidifying Tray to

Water Tank

 

avoid spilling water.

 

2 Remove the Water Tank and Humidifying filter from the Humidifying Tray. Drain ac- cumulated water by tilting the Humidify- ing Tray slowly.

Do not hold this part.

Humidifying filter

Humidifying

Tray

3 Rinse the inside of the Humidifying Tray with lukewarm water to remove impurities.

• Do not remove the Float Styrofoam float .

• Clean difficult-to- reach parts with a cotton-tipped swab or tooth brush.

4 Replace the Humidifying filter and re- place the Humidifying Tray in the unit.

The Humidifying filter will not

Color:Gray

fit if placed in backwards. Be

 

sure there is no gap between

 

the Humidifying tray and the

 

unit when the Humidifying Tray

 

is replaced in the unit. The unit

 

may not operate properly if the

 

Humidifying Tray is not prop-

 

erly replaced in the unit.

 

If the Styrofoam float comes off, replace by inserting the tabs of the Float into the holes in the Humidifying Tray as shown in the diagram.

When Water Deposits are Difficult to Remove

1 Fill Humidifying Tray halfway with lukewarm water, add a small amount of mild kitchen detergent, and leave to soak for about 30 minutes.

Dilute detergent according to instructions on the container. Clean difficult-to-reach parts with a cotton swab or tooth brush.

2 Rinse the Humidifying Tray with lukewarm water.

Rinse until all detergent residue is removed.

Inadequate rinsing may cause the detergent odor or changes

in the shape/ color of the main unit.

CAUTION

Use only mild kitchen detergents to clean the Humidifying Tray. Use of non-designated chemicals or deter- gents can cause deformation, tarnish- ing, cracking (water leakage).

Insert the float below this tab.

Insert the tab on the other side of the float into the hole.

ENGLISH

E-17

Image 19
Contents Manuel D’UTILISATION Purificador DE Aire AIR PurifierManual DE Operación Please read before operating your new Air Purifier English For Customer Assistance the United States Consumer Limited Warranty for U.S. Users Consumer Limited WarrantyFor Customer Assistance Canada Limited Warranty Important Safety Instructions Filter Guidelines Installation GuidelinesPlace on a stable surface with sufficient air circulation Rating Label Illustrative Diagram Front BackPart Names Handle2 locations left and right SensorsFront Monitor Main Unit DisplayDust Monitor Install the True Hepa filter Filter InstallationRefilling the Water Tank About Automatic Humidify Mode Clean AIR & Humidify ModeClean AIR Mode Press the Clean AIR Mode Button on the displayPollen mode operation Quick Clean ModeMAX operation Medium operation LOW operation With the unit OFF, press the Fan Speed Button for 3 seconds Water Supply Indicator LightSound indicator setting for water supply Press the Power OFF ButtonUnit Care and MaintenanceWashable Deodorizing Filter Care Water TankReplace the filter in unit. See E-10 Rinse the Humidifying Tray with lukewarm water Humidifying TrayPreparingtion. the descaling solu Humidifying FilterRemove the Water Tank and Humidifying Tray Remove the Humidifying filter From the Humidifying TrayWashable Deodorizing filter Up to 5 years after opening Filter Replacement GuidelinesHumidifying filter Symptom TroubleshootingFlashing of the Quick Clean Lamp Indication Error Details RemedyFlashing of the Clean Air Humidify Indicator LightStandby Power SpecificationsEnglish Page Humidifie Capte LA PoussièreAtténue LES Odeurs RafraîchitPour Téléphoner Composez le 1-905-568-7140 pour Pour Vous ProtégerGarantie Limitée Instructions DE Sécurité Importantes Ne nettoyez l’extérieur qu’avec un chiffon doux Guide D’INSTALLATIONPrécautions Concernant LE Fonctionnement Guide D’UTILISATION DES FiltresDOS DE L’APPAREIL Poignée 2 emplacements, gauche et droit CapteursDésignation DES Pièces Schéma Illustratif AvantLampe témoin du Plasmacluster bleue Affichage DE L’UNITÉ PrincipaleMoniteur Avant Moniteur DE PoussièreInstallez le filtre Hepa authentique Installation DES FiltresReplacez le réservoir d’eau dans l’appareil Remplissage DU Réservoir D’EAUAprès le remplissage, serrez bien le bou Chon du réservoirFonctionnement Mode D’ÉPURATION DE L’AIRPropos du mode d’humidification automatique Bouton de vitesse du Bouton de ModeFonctionnement Moyen Mode D’ÉPURATION RapideFonctionnement en mode Pollen Fonctionnement MaximumAppuyezl’appareil. sur le bouton d’arrêt de Lampe D’ALIMENTATION EN EAURéglage d’indicateur sonore de l’alimentation en eau AnnulationPanneau Arrière ET Capteurs Soin ET EntretienAppareil Cycle d’entretien Chaque jour en cas d’humidification Réservoir D’EAUToyez le bac BAC D’HUMIDIFICATIONLa fréquence du cycle d’entretien dépend de la dureté de l’ MoisRetirez le réservoir d’eau et le bac d’humidification Filtre D’HUMIDIFICATIONRetirez le filtre d’humidification du bac d’humidification Guide de remplacement des filtres Guide DE Remplacement DES FiltresSymptôme Résolution DES ProblèmesDE L’ERREUR Affichage Lumineux Origine SolutionConsommation en veille CaractéristiquesFrançais Lea antes de operar su nuevo Purificador de aire Refresca Atrapa EL PolvoDisminuye LOS Olores Reduce EL Polen Y MohoInstrucciones DE Seguridad Importantes Pautas Para LA Instalación Precauciones Relacionadas CON LA OperaciónPautas Para EL Filtro Manija 2 ubicadas a la derecha e izquierda Sensores Diagrama Ilustrativo Parte FrontalNombre DE LAS Partes Parte PosteriorMonitor Frontal Pantalla DE LA Unidad PrincipalMonitor DE Polvo Instale el filtro Hepa Instalación DEL FiltroAsegurarlas superiores en su lugar Reemplace el tanque de agua en la unidad Llenado DEL Tanque DE AguaDespués de llenar, apriete bien la tapa del TanquePresione el botón Modo Clean AIR Aire Limpio en la pantalla Modo Clean AIR Aire LimpioSobre el Modo Automatic Humidify Humidificador automático Operación Baja Modo Quick Clean Limpieza RápidaOperación Máxima Operación MediaOperación CancelaciónNo use fluidos volátiles Cuidado Y MantenimientoUnidad Limpie y seque con un paño suaveReemplazo del filtro en la unidad. Vea S-6 Tanque DE AguaCiclo de cuidado a diario cuando use el humidificador Humidificador Bandeja DEL HumidificadorEnjuague la bandeja del humidificador con agua templada Para usar ácido cítrico Filtro DEL HumidificadorRetire el tanque de agua y la bandeja del humidificador Tenga cuidado de no derramar agua cuando limpie el filtroHasta 2 años después de abrirlo Pautas Para Reemplazar EL FiltroFiltro del humidificador Filtro True Hepa Hasta 5 años después de abrirloSíntoma Localización DE FallasSeñal Luminosa Detalles DE Error Solución Energía de reserva EspecificacionesEspañol Osaka, Japan New Jersey 07495-1163 U.S.A Ontario L4Z 1W9 CanadaSharp Plaza, Mahwah Britannia Road East Mississauga

KC-860U specifications

The Sharp KC-860U is an innovative air purifier and humidifier designed to provide a healthier living environment. This multifunctional device combines advanced air cleaning technologies with humidification capabilities, making it particularly beneficial for households seeking to enhance air quality and comfort.

One of the standout features of the KC-860U is its unique Plasmacluster technology. This patented system releases positive and negative ions into the air, which work to neutralize airborne pollutants, including bacteria, viruses, mold spores, and allergens. The Plasmacluster ions essentially mimic the purification process that occurs in nature, creating a fresher atmosphere inside your home.

Another key characteristic of the KC-860U is its HEPA filter. This filter captures at least 99.97% of particles that are as small as 0.3 microns, including dust, pollen, pet dander, and smoke. The combination of HEPA filtration and Plasmacluster technology ensures that harmful substances are effectively removed from the air, providing you with peace of mind that your indoor environment is safe and clean.

The device is also equipped with an activated carbon filter that effectively absorbs odors and volatile organic compounds (VOCs). This feature is particularly useful in kitchens or areas with pets, as it helps to eliminate unwanted smells and chemicals from the air.

In terms of humidity control, the KC-860U boasts a built-in humidifier that adds moisture to dry air, improving overall air quality. This is especially important in winter months or arid climates where low humidity can lead to discomfort, dry skin, and respiratory issues. The humidifier operates quietly, allowing for seamless integration into daily life without disturbing your peace.

The KC-860U is designed for convenience and ease of use. It features a user-friendly interface with intuitive controls, allowing you to adjust settings effortlessly. Additionally, it includes a filter replacement indicator, ensuring that you are always aware of when maintenance is required.

With its sleek design, the Sharp KC-860U is not just functional but also complements modern home aesthetics. It operates efficiently and is suitable for medium to large-sized rooms, making it a versatile choice for various living spaces.

In summary, the Sharp KC-860U stands out as a robust air purification and humidification solution, combining advanced Plasmacluster ion technology, HEPA filtration, and an effective humidifier. Whether you are combating allergens or simply seeking a fresher environment, this device delivers high performance and comfort in one sleek package.