HP x2 1011 G1 (Windows 8.1) manual Restoring factory settings in Computer Setup

Click the Exit icon in the lower-right corner of the screen, and then follow the on-screen instructions.

– or –

Select Main > Ignore Changes and Exit, and then follow the on-screen instructions.

●To save your changes and exit Computer Setup menus:

Click the Save icon in the lower-right corner of the screen, and then follow the on-screen instructions.

– or –

Select Main > Save Changes and Exit, and then follow the on-screen instructions. Your changes go into effect when the computer restarts.

Restoring factory settings in Computer Setup

NOTE: Restoring defaults will not change the hard drive mode.

To return all settings in Computer Setup to the values that were set at the factory, follow these steps:

1.Turn on or restart the computer, and then press esc or hold down the volume button while the “Hold the Volume Down button to enter the BIOS Startup Menu” message is displayed at the bottom of the screen.

2.Press or tap f10 to enter Computer Setup.

3.Select Main > Restore Defaults.

4.Follow the on-screen instructions.

5.To save your changes and exit, click the Save icon in the lower-right corner of the screen, and then follow the on-screen instructions.

– or –

Select Main > Save Changes and Exit, and then follow the on-screen instructions. Your changes go into effect when the computer restarts.

NOTE: Your password settings and security settings are not changed when you restore the factory settings.

76 Chapter 11 Computer Setup (BIOS), MultiBoot, and HP PC Hardware Diagnostics (UEFI)