HP 8 II 1411 manual

Page 27

1.Disconnect the following cables from the system board:

(1)TouchScreen ZIF connector and cable

(2)Controller ZIF connector and cable

(3)Speaker cables (must be unsoldered, see Speakers on page 19)

(4)Power/button board ZIF connector and cable

(5)Front-facing webcam cable

(7)Rear-facing webcam cable

2.Remove the three Phillips PM1.5×2.5 screws (1) that secure the system board to the display panel assembly.

3.Detach the left side of the system board (2) from the display panel assembly. (The left side of the system board is attached to the display panel assembly with double-sided adhesive.)

System board 21

Image 27

Contents HP 8 G21411 Tablet Software terms Product noticeSafety warning notice Iv Safety warning notice Table of contents Power cord set requirements Product description Serviceability Category DescriptionOperating system External component identification Illustrated parts catalog 785180-001 Tablet major componentsSequential part number listing Miscellaneous partsSequential part number listing Removal and replacement preliminary requirements Service considerationsTools required Grounding guidelines Typical electrostatic voltage levelsEvent 10% 40% 55% Packaging and transporting guidelines Material Use Voltage protection level Equipment guidelinesDescription Spare part number Removal and replacement proceduresTablet component replacement procedures Back coverPage Battery Power/volume button board Front-facing webcam Page Rear-facing webcam Speakers System board Page Page Specifications Backing up and recovering your data Factory data resetUpdating apps, widgets, and the operating system Country/region Accredited agency Applicable note number Power cord set requirementsRequirements for all countries Requirements for specific countries and regionsPower cord set requirements Recycling Index