HP Tape manual

Page 74

An external HP Surestore DLT1 drive will operate using any voltage in the range 100–240 volts (50-

60 Hz). No adjustment is needed. To connect your drive to the power supply, proceed as follows:

1Plug the power cable securely into the socket on the rear panel of the drive. (See figure 3.)

2Plug the other end of the power cable into the power outlet.

Write the model name, product number, serial number, and SCSI ID of your drive at the back of this guide for future reference. The model name is on the front of the drive and the product and serial numbers are on a label on the bottom of the drive.

11

Image 74

Contents Date CopyrightRevision history OctoberObtaining technical support North and south america Europe, middle east and africa Asia pacific Warranty WarrantyWarranty conditions ExclusionsCustomer service form Before you start Resetting the drive Switching on the driveIf you have problems during self test OperationWrite Protected first light Front panel lightsFront panel lights Ready second lightTo unload a cartridge Loading and unloadingTo load a cartridge To label a cartridgeCartridge care Cleaning cartridge CleaningCleaning strategy Cleaning the tape heads on a driveFeatures and specifications Choose your model from the bulleted list belowHp surestore dlt1i Dlt1e Hp surestore dlt1eNon-operating limits storage ranges Action Drive Media compatibilityDLT1 compatibility matrix DLT4000 DLT7000Diagnostics Troubleshooting Frequently asked questions FAQsScsi configuration This topic is available in English only ModelCreating the device files HP-UX systems series 700 onlyDetermining the Scsi id ExampleConfiguring for Digital Unix DEC systems, Digital UnixIBM RS/600 systems, AIX Configuring the device filesScsi configuration Unix configuration hp systems Device file names under AIXPC-based UNIX, SCO and Linux Silicon Graphics systems, Irix Mtcan and constants valuesFor all adapters Sun systems, Solaris 2 SunOSHp-data values Value MeaningOverview Verify the installationVerifying the installation System-specific argumentsGlossary Rail kits Ordering suppliesAdapters MediaOrdering supplies DLT1 Secure the drive Scsi ID Mounting bay Scsi host bus adapterScsi ribbon cable Mounting hardwareBackup software User documentation HP product registrationDrivers HP Library & Tape ToolsChecking the drive’s Scsi ID Page Preparing mounting bay in a Page Attaching tray for NetServer L-Series servers Page Installing the drive Page Attaching Scsi and power cables to internal drive Page Securing the drive side mounting screws shown Page Tape drive controls and indicators Front panel LEDs ReadyWrite protecting cartridges Looking after cartridges Cleaning cartridgesWrite-protecting cartridges Loading a cartridge To unload a cartridge Check operationTo load a cartridge Using HP Library & Tape Tools Page If you have Internet access, register electronically If you do not have internet accessNone of the drive’s LEDs illuminate Other sources of information Page External tape drive Check the drive’s Scsi ID Connect the power cableTroubleshooting Connect the Scsi cableScsi ID Scsi cable Backup software HP product registration Checking the Scsi ID Page Connecting the Scsi cable Page Connecting the power cable Page Tape drive front panel Front panel LEDs Write-protecting cartridges Write-protecting cartridges Loading a DLTtape cartridge Check operation Using HP Library & Tape Tools Page If you have internet access, register electronically None of the drive’s LEDs illuminate All of the LEDs on the front panel blink continuallyIs properly terminated