HP LP 2000r manual Before you begin installation

Page 28

HP Netserver High Density Rack Solutions Overview (LP 2000r)

Preparing the HP Netserver for 2-post rack installation

Each HP Netserver has two rails attached at the factory and shipped to customers. These two rails must be removed to attach the brackets, before the Netserver can be mounted in the rack.

1. Lay the HP Netserver on a flat surface.

2.Remove the 3 screws holding the rails to each side of the chassis. See figure above.

3.Refer to the installation instruction for the HP J1527A Slide Rackmount Kit and HP J1480A 2-post Slide Mount Adapter.

Before you begin installation

Step 1. Verify that the floor where the equipment will be located can support the weight. Also verify that there is enough space for slide mounted equipment to be fully extended and that doors can swing freely.

Step 2. Verify that the appropriate electrical power is available.

Step 3. Unpack and place rack at the designated location.

Step 4. Secure and level the rack(s) using the leveling feet. Be sure to deploy the anti-tip feet, if appropriate.

Step 5. Install the equipment.

23

Image 28

Contents Hp netserver high Density rack solutions Overview Planning your rack system for LP 2000rExecutive Summary Websites PublicationsHP Netserver website http//netserver.hp.com Reader Assumptions Table of Contents HP Netserver High Density Rack Solutions Overview LP 2000r Safety and Regulatory Information Safety WarningsGlossary HP Netserver High Density Rack Solutions Overview LP 2000r Determine power requirements for the servers Planning your racked systemPower up sequence Power down sequenceCircuit breakers ServerCheck your calculations Input Power watts x 3.41=Thermal dissipation BTU/hrX 3.41 = 2,431 BTU/Hr Power consumption worksheet sample Category Part Number DescriptionPower consumption worksheet actual Gauge columns provide strength Anti-tip foot HP Rack System/EVentilation Strength MobilityEase of Use StabilityHP Rack Accessories For Use with HP Rack Model Number ContentFront doors, side panels and tie kits For Use with HP Rack Model NumberUse Tie Kit Kit Contains HP Rack System/E Cable Management AccessoryMount Fastener Voltage Current Outlets HP Product Number Type HP Power Distribution OptionsE7675A E77671A E7676A HP Netserver High Density Rack Solutions Overview LP 2000r Uninterruptible Power Supplies UPS Power = Vol ts x AmpsDescription Includes Console SwitchAvailable HP Rackmount Flat Panel Monitor and Keyboard HP Rack System/E Vertical Extension KitKit Contains HP Model Number HP Vertical Extension Kit IncludesInstallation Flexible installation optionsPost HP System/E racks or EIA standard cabinets Slide mountingMarking the rack Marking Rack ColumnsFixed, center mounting Post EIA standard non-HP racks 3 optionsFixed, flush mounting Marking the Rack Location Marks on the Racks Front ColumnsBefore you begin installation Preparing the HP Netserver for 2-post rack installationInstalling the Uninterruptible Power Supplies Installing the serversInstalling Power Distribution Units PDUs can be mounted on the rearCable Management HP System/E racksAttach the Cable Management Arm Attach the main cable guidesSecure each cable bundle Begin routing the cablesRoute the cables to their destination Maintain the ambient temperature Conclusion HP Netserver High Density Rack Solutions Overview LP 2000r