HP J3188A Troubleshooting LED Operation, Diagnostic Tips, Power Coll, Fast, Flash, Chapter, Slow

Troubleshooting

LED Operation

Troubleshooting

LED patterns indicating problems						Diagnostic Tips
Power	Coll	Port LED	Sec	Fault	RPS
ON	*	Fast	Fast	*	*	A security violation has occurred on
		Flash	Flash			the port that is flashing. See SEcure
						command for definition and details in
						Chapter 3.
ON	*	Slow	*	Slow	*	The port has been auto-partitioned
		Flash		Flash		because of an excessive collision
						condition. Check cable connections
						and status of attached network devices
						for causes of the excess collisions. The
						hub will automatically recover after
						certain IEEE 802.3 criteria are
						successfully met.
ON	*	*	Fast	*	*	Network management security
			Flash			violation occurred. See SEcure
						command for details.
ON	*	*	*	ON	*	The hub has failed its self-test. Power-
						cycle the hub. If this condition persists,
						call your HP-authorized LAN dealer or
						HP representative for assistance.
ON	*	*	*	*	OFF	The internal power supply is operating
						properly and the RPS is not being used.
ON	*	*	*	*	ON	The internal power supply has failed or
						has been unplugged and the RPS has
						been activated as the current
						operating power supply.
*This LED is not important for the diagnosis.

2-4