Managing the Hub
Managing the Hub
Console Command Reference
network management— also called SNMP event alarms). The start of the table is shown below. Up to ten network management stations can be entered into the table. Entry 0 (zero) is used for the “all managers allowed” entry.
ID | Manager Address (IP or IPX) | Receive Alarms? |
|
|
|
0 | All managers allowed | NA |
|
|
|
1 |
|
|
|
|
|
2 |
|
|
|
|
|
The hub is initially shipped with all network management stations allowed to manage the hub, but the “all managers” entry does not identify where alarms are to be sent. Specific addresses must be entered into the table to identify where the alarms should be sent.
N o t e | If you want to restrict which management stations are allowed to manage the |
| hub, delete entry 0. Then add the allowed management stations with the A |
| command. |
| At the interface prompt, enter MA; the current authorized managers list is |
| |
| displayed and you are prompted to add or delete an entry in the list, or to enter |
| E to end your editing. |
| To add an entry, enter A at the prompt. Enter the IP or IPX address of the |
| network management station, or enter A to allow all managers to manage the |
| hub, then indicate at the next prompt whether this management station should |
| receive alarms generated by the hub. A new entry is added to the list. |