NOTE
NOTE
Installing and Configuring Serviceguard NFS
Configuring a Serviceguard NFS Package
#NFS_SERVICE_NAME[0]=nfs.monitor
#NFS_SERVICE_CMD[0]=/etc/cmcluster/nfs/nfs.mon
By default, the NFS_SERVICE_NAME and NFS_SERVICE_CMD variables are commented out, and the NFS monitor script is not run.
The Serviceguard A.11.13 configuration file includes the following changes:
•AUTO_RUN replaces obsolete PKG_SWITCHING_ENABLED.
•LOCAL_LAN_FAILOVER_ALLOWED replaces obsolete
NET_SWITCHING_ENABLED.
4.To enable File Lock Migration (available on 11i v1 and 11i v2), set the NFS_FILE_LOCK_MIGRATION variable to 1:
NFS_FILE_LOCK_MIGRATION=1
By default, this variable is set to 0 (disabled). The NFS_FLM_SCRIPT variable is the name of the script that manages synchronization of the file lock status entries for the primary and adoptive nodes associated with this HA/NFS package. By default, this is set to nfs.flm. You must assign a unique name to this script in every HA/NFS package in the cluster (for example, nfs1.flm, nfs2.flm, and so on):
NFS_FLM_SCRIPT="${0%/*}/nfs1.flm"
If you wish to monitor the File Lock Migration script, then you must also set the NFS_FILE_LOCK_MIGRATION and NFS_FLM_SCRIPT variables in the NFS monitor script.
If you enable File Lock Migration, then you can configure the File Lock Migration script (see “Editing the File Lock Migration Script (nfs.flm)” on page 42).
The file name of the NFS_FLM_SCRIPT script must be limited to 13 characters or fewer.
Chapter 2 | 41 |