HP UX System Adstration manual UDPLOOPBACKSOURCE% and %UDPLOOPBACKLOG% tokens

e.Replace the <%FS%> token with the filesystem or directory where the consolidated logs will be kept. This filesystem/directory is the one managed by the Serviceguard package. For example:

destination d_syslog { file(“<%FS%>/syslog/syslog.log”); }; becomes:

destination d_syslog { file(“/clog/syslog/syslog.log”); };

Make sure that this filesystem mount point exists cluster-wide and that the storage fails over correctly cluster-wide. Since consolidated logs can grow quite large, HP recommends that this filesystem use the largefiles option and that there is sufficient room for growth.

For additional information on creating the Serviceguard storage/filesystem configuration for a package, refer to the Managing Serviceguard manual.

3.Manually replace the tokens in /etc/syslog-ng.conf.clientas follows:

a.If configuring the cluster to consolidate its own syslogs, replace the

<%UDP_LOOPBACK_SOURCE%> token with: source s_syslog_udp { udp(port(514)); };

Replace the <%UDP_LOOPBACK_LOG%> token with:

log { source(s_syslog_udp); destination(d_syslog_<type>); };

where <type> is either tcp or udp depending on the desired log transport. This causes syslog-ngto read the local syslogd’s UDP messages and send them to the log consolidation server.

If you do not want to consolidate the local syslogs of this cluster, delete the

<%UDP_LOOPBACK_SOURCE%> and <%UDP_LOOPBACK_LOG%> tokens.

b.Replace all the <%TYPE%> tokens with either tcp or udp depending on the desired log transport.

c.Find the line: “destination d_syslog_<%TYPE%>{ <%TYPE%>(“<%IP%>”port(<%PORT>%>)); };.”

Replace <%IP%> with the IP address of the clog package. For TCP, replace <%PORT%> with the TCP port used for log forwarding (selected above). For UDP, replace <%PORT%> with 514, the standard UDP port.

62 Consolidated Logging