HP Scitex FB700 Industrial manual Environmental, Table A-6Printer environmental specifications

Required power cord

The printer can use any of the following 4.5 m (14.8 ft) power cords:

● USA: HP part number 8120–6903

● Europe: HP part number 8120–6899

● Cord without connector to electric outlet (for use with customer-

supplied connector): HP part number 8120–6895

Optional auxiliary power for ink system vacuum

When configured as shipped, if the power cord to the printer is removed,

power to the ink system vacuum is removed. If the printer standby power

switch is switched off, but the power cord is not removed, power to the

vacuum is preserved. The ink system vacuum maintains the negative

pressure required for printing operation and prevents ink dripping from the

printheads when the printer is idle.

You can preserve power to the ink system vacuum during power outages

by connecting the supplied power cord (length: 137 cm (4.5 ft)) from the

auxiliary power connection (below the ink box racks) to one of the

following:

● Wall outlet — 100-240 VAC, 50/60 Hz, provides temporary power to

the vacuum system when it is necessary to remove power from the

printer for service.

● UPS — customer-supplied uninterruptable power supply, output

100-240 VAC, 50/60 Hz, minimum of 15 watts of power, provides

battery backup to the vacuum system in the event of a power failure.

UPS is connected to the electric wall outlet.

Operating conditions

Temperature: 20–30° C (68–85° F )

Relative Humidity: 20–80%, non-condensing (40–60% recommended to

avoid static electricity on synthetic media that occurs below 40%, and

buckling on paper-based media over 60%.)

Maximum operating altitude: 3000 m (10,000 ft)

Storage conditions

Temperature: -34–49° C (-30–120° F)

Relative Humidity: 10–80%, non-condensing

86 Appendix A Specifications

ENWW