
There are three steps to set up custom paper. When all are completed, the display returns to the PAPER HANDLING menu. After a custom size is set for a tray, the printer retains the setting until you change it in the control panel.
2
x
y
1
1
X dimension
2
Y dimension
Unit of measure
1.Press
to highlight UNIT OF MEASURE, and then press
.
2.Press
or
to highlight the correct measurement, and then press
.
X dimension
The X dimension is the width of the page as it feeds into the printer.
1.Press
to highlight X DIMENSION, and then press
.
2.Press
or
to highlight the correct value, and then press
.
Y dimension
The Y dimension is the length of the page as it feeds into the printer.
1.Press
to highlight Y DIMENSION, and then press
.
2.Press
or
to highlight the correct value, and then press
.
Configuring tray 2 or tray 3 for custom paper
The printer automatically detects many sizes of paper, but you can also configure trays for custom paper sizes. You must specify the following parameters:
●Unit of measure (millimeters or inches)
●X dimension (the width of the page as it feeds into the printer)
●Y dimension (the length of the page as it feeds into the printer)
ENWW | Configuring trays | 55 |