HP LA8205B, Pro/10+ ISA manual Windows NT Workstation Version Requirements

3Connecting to a Windows NT Server 3.51 Windows NT Workstation Version 4.0

Windows NT

Workstation

Version 4.0

Requirements

•HP Vectra with Windows NT Workstation 4.0 Service Pack 3.

•Intel EtherExpress PRO/10+ ISA Ethernet card and drivers disk.

•Driver Name: EPRO.SYS Size: 11KB Date: 4/14/97

•Microsoft Windows NT Workstation 4.0 and Service Pack Media.

(If you have a Hewlett-Packard preloaded HDD, the media is located at “C:\I386”)

•Microsoft Windows NT Server 3.51 machine that supports Net BEUI, TCP/ IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

Device Configuration

		Vectra VL8	Vectra VL7		Vectra VE7/VE8
	I/O Address	210-21Fh	210-21Fh		300-30Fh
	Interrupt	10	10		11 (16 bit only)
•	Board Connector type			Auto-detect
•	Force 8-bit	operation		Yes
•	Flash chip address			Disabled
•	Remote boot program			None

Procedure

1With the HP Vectra turned off, install the Intel EtherExpress PRO 10+ ISA Ethernet adapter card into an ISA slot.

2Connect network cable media to the Intel EtherExpress PRO ISA Ethernet adapter card.

3Insert a DOS bootable diskette and power on the machine.

4After booting, insert the Intel EtherExpress drivers disk Ver. 3.5, and execute “A:\SOFTSET2.EXE.”

5Select “Change Adapter configuration” and verify the resource settings listed above under the heading “Device Configuration.”

6If changes are required, save those changes and exit.