4 Connecting to a Windows NT Server 4.0
Windows for Workgroups Version. 3.11
Windows for Workgroups Version. 3.11
4 Connecting to a Windows NT Server 4.0
Requirements
•HP Vectra with DOS and
•Intel EtherExpress Pro 10+ ISA Ethernet adapter card and drivers disk Ver. 3.5.
•DriverName: EPRO.386 Size: 16K Date: 10/22/96
•Microsoft Windows NT server 4.0 machine that supports Net BEUI, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
|
|
| Vectra VL8 | Vectra VL7 |
| Vectra VE7/VE8 |
|
|
|
|
|
|
|
| I/O Address |
|
| |||
|
|
|
|
|
|
|
| Interrupt |
| 10 | 10 |
| 11 (16 bit only) |
|
|
|
|
|
| |
• | Board Connector type |
| ||||
• | Force | operation |
| Yes | ||
• | Flash chip address |
| Disabled | |||
• | Remote boot program |
| None |
Procedure
1With the HP Vectra turned off, install the Intel EtherExpress PRO ISA Ethernet adapter card into an ISA slot.
2Connect network Cable Media to the Intel EtherExpress card.
3Power on the machine.
4After booting, insert the Intel EtherExpress drivers disk Ver. 3.5”, and execute “A:\SOFTSET2.EXE.”
5Select “Change Adapter configuration” and verify the resource settings listed above under the heading “Device Configuration.”
6If changes are required, save those changes and exit.