4Connecting to a Windows NT Server 4.0 Windows NT Workstation Version 3.51
Windows NT
Workstation
Version 3.51
Requirements
•HP Vectra with Microsoft Windows NT Workstation 3.51 installed.
•Intel EtherExpress Pro 10+ ISA Ethernet card and drivers disk Ver. 3.5.
•DriverName: EPRO.SYS Size: 10KB Date:4/14/97
•Microsoft Windows NT Workstation 3.51 and Service Pack Media.
•Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/ IP,NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
|
|
| Vectra VL8 | Vectra VL7 |
| Vectra VE7/VE8 |
|
|
|
|
|
|
|
| I/O Address |
|
|
|
|
|
|
|
|
|
|
|
|
| Interrupt |
| 10 | 10 |
| 11 (16 bit only) |
|
|
|
|
|
| |
• | Board Connector type |
| ||||
• | Force | operation |
| Yes | ||
• | Flash chip address |
| Disabled | |||
• | Remote boot program |
| None | |||
Procedure
1With the HP Vectra turned off, install the Intel EtherExpress PRO 10+ ISA Ethernet adapter card into an ISA slot.
2Connect network cable media to the Intel EtherExpress PRO 10+ ISA Ethernet adapter card.
3Insert a DOS bootable diskette and power on the machine.
4After booting, insert the Intel EtherExpress drivers disk Ver. 3.5” and execute “A:\SOFTSET2.EXE.”
5Select “Change Adapter configuration” and verify the resource settings listed above under the heading “Device Configuration.”
6If changes are required, save those changes and exit.
7Remove the Intel drivers diskette and reboot the machine.
8After Windows loads, go to the “MAIN” program group , and