Adjust heater and print mode settings
If you see banding in all colors and you have already performed media advance calibration, then you can try adjusting the heater temperature and print mode settings.
Banding in all colors may be caused by the following factors:
●Small print dot size: heat will cause a smaller dot size. The higher you set the heater temperature, the smaller the dot size is which results in light banding.
●Ink absorption by the media: if the media you are using is not capable of absorbing the ink as it is placed, then this can result in dark banding.
To improve ink placement and absorption try the following:
●Set a lower print heater temperature for light banding or a higher temperature for dark banding.
●Change the print mode to reduce the quantity of ink placed on the media for dark banding.
●Change the print mode from bidirectional printing to unidirectional printing for dark banding. After each change to a setting, try printing the nozzle print pattern to check the image quality. To change the heater temperature and print mode settings:
1.Press the ONLINE key and select the MEDIA REG menu with the 
key.
2.Select PRINT HEATER T in the MEDIA REG menu with the 
and 
keys.
Parameters: 15 °C to 55 °C, or ** to turn the heater off.
NOTE This value will only be applied if the HEATER PREF option is set to HEAT
PANEL.
3.Select the number you want to change by using the 
and 
keys and change the numeric value using the 
and 
keys.
4.Press the OK key to confirm the parameter.
Print the nozzle print pattern to check the image quality.
5.To change the Print mode:
Select PRINT MODE. in the MEDIA REG menu with the 
and 
keys.
How do I get the best image quality
ENWW | Adjust heater and print mode settings | 127 |