HP 1200 manual TCP/IP protocol information, Host Name, IP Address, Subnet Mask, Default Gateway

	TCP/IP protocol information
Message	Description
Status	The current TCP status:
	Ready: The print server is waiting for data over TCP/IP.
	Disabled: TCP/IP was manually disabled.
	Initializing: The print server is searching for the BOOTP
	server or trying to get the configuration file through TFTP. An
	additional status message might also display.
	Note
	If the print server is not ready, an error code and message
	displays.
Host Name	The host name configured on the print server. The host name
	might be truncated.
	Not Specified: No host name was specified in a BOOTP
	response or TFTP configuration file.
	NPIxxxxxx: The default name is NPIxxxxxx, where xxxxxx is
	the last six digits of the LAN hardware (MAC) address.
IP Address	The Internet Protocol (IP) address assigned to the print
	server. This is a required entry for its operation on a TCP/IP
	network. During initialization, a temporary value of 0.0.0.0
	displays. After two minutes, a default IP address of
	192.0.0.192 is assigned, which might not be a valid IP
	address for your network.
	Not Specified: An IP address is not assigned or the value is
	zero.
Subnet Mask	The IP subnet mask configured on the print server. During
	initialization, a temporary value of 0.0.0.0 displays. Depending
	on the configuration parameters, the print server might
	automatically assign a usable default value.
	Not Specified: A subnet mask is not configured.
Default Gateway	The IP address of the gateway used when sending packets off
	of the local network. You can only configure one default
	gateway. During initialization, a temporary value of 0.0.0.0
	displays. If an IP address is not provided, the print server’s IP
	address is used.
	Not Specified: A default gateway is not configured.

EN Understanding the print server configuration page 173