HP T1000J, T1000 G3, T1500 G3, T750J, T750 G2, T1500J manual Self‐Test

Page 19

OPERATION

the Self‐Test

NOTE: The batteries must be fully charged and the UPS must not be in Battery mode to perform the self‐test.

Press and hold the (Test/Alarm Reset) button for three seconds to initiate the self‐test. During the five-second test, the bar graph indicators cycle through twice. If the UPS beeps or a UPS alarm indicator stays on, see “Troubleshooting” on page 27.

12	HP T750 G2, HP T750J, HP T1000 G3, HP T1000J, HP T1500 G3, and HP T1500J UPS Models User Guide S 505922-002

Image 19

Contents Part Number 505922-002 July 2009 Second Edition Audience assumptions Page Regulatory compliance identification numbers Compliance noticesDischarge Japanese notice Battery replacement noticeGrounding methods to prevent electrostatic discharge Contents Shows the HP T750 G2 UPS 1IntroductionIntroduction Important Safety Instructions Safety WarningsUPS Internal Battery 3InstallationEquipment Removing the Battery Cover Replace the metal battery cover Replace the UPS front bezelUPS If the UPS beeps or a UPS alarm indicator stays on, see onThis section shows the UPS rear panels Rear PanelsHP T750 G2, 230V Rear Panel HP T1500 G3, 230V Rear Panel 4Operation UPS on BatteryUPS On Mode UPS OffFront Panel Self‐Test Configuration Additional UPS FeaturesOptions DIP Switch SettingsSerial Port Serial Port Pin Assignment HP Power Manager Power Manager SoftwareTransient Protector Battery Care UPS MaintenanceUPS and Batteries Disconnecting the Internal Battery ConnectorSpares Battery SparesBatteries Removing the Battery Cover New Batteries Used Battery or UPS Model List 7SpecificationsElectrical Output Battery Alarms and UPS Conditions 8TroubleshootingTroubleshooting Guide You Contact HP SupportContact Information Battery Warranty Warranty InfromationWarranty Computer Load Protection Guarantee