5 | Additional UPS Features |
This section describes:
SVoltage configuration
SUSB port and serial port
SNetwork transient protector
SHP Power Manager software
Configuration
The DIP switches on the rear panel of each unit (see Figure 14) are used to configure the output voltage and input voltage range.
To configure voltage:
1The UPS must be completely shutdown.
To turn off the UPS, press and hold the (On/Off) button for two seconds and then unplug the UPS from the power outlet.
2Set the DIP switches according to the configurations in Table 1 on page 14.
3Plug the UPS power cord into a power outlet.
4Press and hold the (On/Off) button until you hear the UPS beep to turn the UPS on.
UPS Rear Panel
OFF
21
ON
Figure 14 DIP Switches
HP T750 G2, HP T750J, HP T1000 G3, HP T1000J, HP T1500 G3, and HP T1500J UPS Models User Guide S | 13 |