Soleus Air KFHIP-09-OD installation manual Install the Outdoor Unit, Install the connection pipe

Page 17
◆Install the Outdoor Unit

Install the Outdoor Unit

Install the connection pipe

 

 

1. Align the center of the piping flare with the valve.

 

 

2. Screw in the flare nut by hand and then tighten

 

 

 

the nut with spanner and torque wrench refer to

 

 

 

right figure.

 

 

 

Tightening Torque Table

 

 

 

 

 

 

 

 

 

 

Hex Nut Diameter

 

Tightening Torque

 

 

 

(mm)

 

N.m

 

 

 

Φ6

 

15~20

 

 

 

φ12

 

50~55

 

Note: Exceeding tightening torque will

 

 

 

 

 

 

 

 

 

 

damage the flare nut.

 

 

 

 

 

 

Electric wiring connection

1.Disassemble the big handle.

2.Remove the wire clamp and connect the end of the power connection cord with screws to the wiring terminal board. Be sure that the wiring connection is in accordance with the indoor unit’s.

3.Fix the wiring with wire clamp. For the heat pump join the two control cords.

4.Make sure that the wiring has been connected securely.

5.Reassemble the big handle.

NOTE:

1.Incorrect wiring connections will cause electrical malfunction.

2.Do not pull the wire when assembling it with wire clamp.

- 15 -

Image 17
Contents OPERATING AND INSTALLATION MANUAL Indoor Unit Outdoor UnitWall Mounted Mini Split Heat Pump Air Conditioner Model KFIHP-09-ID / KFHIP-09-ODTABLE OF CONTENTS Name of Each Part Structure and OperationThe Instructions before Use Set the room temperature appropriately The Instructions before UseModel Specification and Technical DataKFIHP-09-ID KFHHP-12-IDFunction-Remotecontrol Remote Control OperationRemote Control Operation Continued How to Insert Batteries Operation The general procedureProcedure for SLEEP mode Installation Location InstallationIndoor Unit Outdoor UnitGrounding Requirement Electric Wiring112.6 inch 212.6 inch Installation Dimension DiagramImportant Notes Install the rear panel InstallationInstall the piping hole Install the drainage hose6.Recover the surface panel InstallationInstall the Indoor Unit Install the connection pipe Install the Outdoor UnitElectric wiring connection Tightening Torque TableInstall the Outdoor Unit Air Purging and Leakage TestCheck after Installation Test Operation and Check after InstallationTest Operation 1.Before Test OperationCare and Maintenance Care and MaintenanceTrouble Shooting Care and Maintenance ContinuedProblem Trouble ShootingProblem Trouble ShootingTrouble Shooting Because the air of the room is cooled down rapidlyUnusual noise can be heard during operation Trouble ShootingElectrical Schematic Diagram Indoor Unit Please Insert Diagram in hereElectrical Schematic Diagram Please Insert Diagram in here Electrical Schematic Diagram Outdoor UnitWarranty