HP RP7 7100 Base Model manual

Page 61

5.Insert the USB device into the USB port.

6.Insert the top of the USB security cover into the I/O panel at an angle with the bottom of the cover slightly raised (1), then rotate the bottom down so that the cover snaps in place (2).

NOTE: If the USB device has a cable, place the cable in the channel on the side of the security cover.

Using the USB Security Cover 55

Image 61

Contents Hardware Reference Guide Hardware Reference Guide About This Book Iv About This Book Table of contents Preventing Electrostatic Damage Grounding Methods Standard Features Product FeaturesOptional HP RP7 Accessories Control Function Front Panel Controls1OSD Main Menu Using the On-Screen Display MenuRear I/O Panel Components Mounting the RP7 to a Wall or Swing Arm Tools NeededInstalling the RP7 Adjustable Stand Page Page Page Page Page Routing Cables to External Devices Page Page Page Installing Optional Integrated USB Modules Page Page Page Page Page Page Page Installing an Optional HP Retail RP7 10.4 Customer Display Page Page Page Page Page Installing an Optional HP Retail RP7 VFD Customer Display Page Page Page Page Page Page DDR3-SDRAM Sodimm Installing MemoryInstalling a Sodimm Page Page Removing and Installing a Hard Drive Page Page Page Page Page Page Page Replacing the Battery Page Page Using the USB Security Cover Page Page Page Securing the RP7 to a Counter Top Padlock Installing an External Security LockInstalling an External Security Lock Touch Screen Calibration Configuring the MSR and VFD Customer DisplayConfiguring Powered Serial Ports Troubleshooting Table A-1Diagnostic Front Panel LEDs and Audible Codes Appendix a Troubleshooting Grounding Methods Preventing Electrostatic DamageComputer Operating Guidelines and Routine Care Touch Screen MaintenanceShipping Preparation Index