HP RP7 7100 Base Model manual Installing an Optional HP Retail RP7 VFD Customer Display

Page 37

13.Replace the rear I/O cover by placing the hooks on the bottom of the cover into the slots on the bottom of the chassis (1). Then rotate the top of the I/O cover up so that it snaps securely onto the chassis (2).

14.Reconnect the power cord and press the power button on both displays.

Installing an Optional HP Retail RP7 VFD Customer Display

The integrated VFD customer display can be installed with no poles attached, or with one or two poles attached, depending on the desired height of the VFD.

1.Turn off the computer properly through the operating system, then turn off any external devices.

2.Disconnect the power cord from the power outlet.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to the internal components of the computer.

Installing an Optional HP Retail RP7 VFD Customer Display 31

Image 37

Contents Hardware Reference Guide Hardware Reference Guide About This Book Iv About This Book Table of contents Preventing Electrostatic Damage Grounding Methods Standard Features Product FeaturesOptional HP RP7 Accessories Control Function Front Panel Controls1OSD Main Menu Using the On-Screen Display MenuRear I/O Panel Components Mounting the RP7 to a Wall or Swing Arm Tools NeededInstalling the RP7 Adjustable Stand Page Page Page Page Page Routing Cables to External Devices Page Page Page Installing Optional Integrated USB Modules Page Page Page Page Page Page Page Installing an Optional HP Retail RP7 10.4 Customer Display Page Page Page Page Page Installing an Optional HP Retail RP7 VFD Customer Display Page Page Page Page Page Page DDR3-SDRAM Sodimm Installing MemoryInstalling a Sodimm Page Page Removing and Installing a Hard Drive Page Page Page Page Page Page Page Replacing the Battery Page Page Using the USB Security Cover Page Page Page Securing the RP7 to a Counter Top Padlock Installing an External Security LockInstalling an External Security Lock Touch Screen Calibration Configuring the MSR and VFD Customer DisplayConfiguring Powered Serial Ports Troubleshooting Table A-1Diagnostic Front Panel LEDs and Audible Codes Appendix a Troubleshooting Grounding Methods Preventing Electrostatic DamageComputer Operating Guidelines and Routine Care Touch Screen MaintenanceShipping Preparation Index