®3
DUAL W-84 INSTALLATION
To control the fan and lights from two locations (a | DIP SWITCHES |
| |
installing the two switches into the wall, place both switches side by |
|
side, then locate the 4 dip switches on the side of the two switches as |
|
shown in Figure #2. Then make sure that the dip switches are set to the |
|
same address on both switches as shown in Figure #2. When setting |
|
these dip switches you are setting the channel number that is required |
|
to control both your fan and lights from both sides of the room. If you are |
|
installing other |
|
reset the dip switches on these other fans to a different channel before |
|
installing your |
|
on channel changing within this part of the operation manual as shown |
|
on page #27. |
|
CAUTION! | (FIGURE #2) |
|
Ensure power is turned OFF at the breaker or fuse panel before starting installation.
T o c o n t r o l t h e f a n a n d l i g h t s f r o m t w o l o c a t i o n s ( a t h r e e - w a y c i r c u i t ) , u s e t w o
1.Remove the screws and switch plate from the existing switch box and the screws holding the switch in the switch box.
2.Pull the existing switch from the switch box to expose the wire connections.
3.Determine which wire is connected to the common
(FIGURE #1)terminal from the power source (120V AC) of the three- way switch. (The terminal will be marked on switch).
4.Remove the wire from the common terminal of the three-way switch. Connect this wire to the remaining black/white striped wire on the W-84 control. Secure this splice with a wire nut.
5.Remove the two remaining wires from the three-way switch. Connect the black wire of these wires to a black wire on the W-84 control. Secure the splice with a wire nut. The remaining red wire is to be connected to the other red wire on the W-84. Secure the splice with a wire nut.
6.Connect the green ground wire coming from the back of the W-84 control to the ground wire in the switch box. Secure the splice with a wire nut.
7.Check your work by using the wiring diagrams as shown in Figures
#1 and #3 on this page.
8.Install the W-84 in the wall box with the two long screws provided. 9.Install the wall plate with the two short color-matched screws
provided.
10.Installation of the second W-84 control is identical. Repeat steps 1 through 7.
2 BLACK Wall Control
WIRES
2 RED WIRES
BLACK AND WHITE
STRIPED WIRE
(FIGURE #3)
14
