Casablanca Fan Company PN9943001 warranty Wall Control Preparation

® 3

W-84 WALL CONTROL PREPARATION

WALL CONTROL AND HARDWARE (not to scale)

Switch Mounting
Screws (2)	Switch Bezels				(4) Wire Cap
W-84				Wall Plate
	(1) White	White Wall	Almond Wall	Screws
Wall Control
	(pre-installed)	Plate (1)	Plate (1)	(2) White
	(1) Almond			(2) Almond

Prepare for W-84 Wall Control Bezel replacement as follows:

Before installing the W-84 wall control you will need to check and see if you will need to change the bezel on the front of the wall control from WHITE to ALMOND. If you are going to use white, skip these steps and go to wall control installation starting on page 24. If you are going to use the ALMOND bezel and wall plate you will first need to change the bezel on the front of the switch before installing the switch in to the wall.

Step 1a. Locate the four (4) tabs holding the bezel to the front of the switch, then press in on each tab one at a time, removing the bezel as shown in Figure #1.

Step 1b. Locate the rubber key pad attached to the four (4) locating pins as shown in Figure #2 and remove rubber key pad from the WHITE bezel, also as shown in Figure #2.

Step 1c. Reinstall the rubber key pad on to the four

(4)locating pins located on the almond bezel as shown in Figure #3.

WHITE

BEZEL

	LOCATING
LOCATING	PINS (4)

PINS

HOLES(4)

RUBBER KEY

PAD

Figure #2

BEZEL

BEZEL

TABS

Figure #1

ALMOND

BEZEL

RUBBER KEY

PAD

Figure #3

11