HP 2000 Base Model manual Unfolding the stand, Adjusting the tilt angle

Page 13

Unfolding the stand

The system ships with the stand in the folded position. To unfold the stand, hold the base down with one hand and push the bottom of display head up so that the neck of the stand adjusts up and back, then tilt the display head forward.

Adjusting the tilt angle

You can adjust the monitor stand height and tilt to a variety of positions. Choose a position that is the most ergonomically appropriate for your usage.

CAUTION: The optimal tilt range of the display head is -5 degrees to +60 degrees. The unit should not be operated outside of the optimal tilt range.

Unfolding the stand

7

Image 13

Contents Hardware Reference Guide Product notice About This Book Iv About This Book Table of contents Preventing electrostatic damage Grounding methods Product overview Standard featuresProduct Models Page Rear components Connecting a serial device Tools needed Hardware upgradesPage Unfolding the stand Adjusting the tilt angleRouting cables to external devices Page Replacing the power supply Page Page Installing optional HP integrated USB peripheral modules Page Page Page DDR3-SDRAM Sodimm Installing memoryRemove the front panel. See Removing the front panel on Removing the front panel Page Replacing the front panel Page Replacing the hard drive Page Page Replacing the battery Remove the front panel. See Removing the front panel on Securing the RP2 to a counter top Cable lock Installing an external security lockPadlock Configuring the MSR Configuring the softwareTouch screen calibration Configuring powered serial ports Table A-1Diagnostic Front Panel LEDs and Audible Codes TroubleshootingAppendix a Troubleshooting Activity Beeps Possible Cause Preventing electrostatic damage Electrostatic dischargeGrounding methods Computer operating guidelines and routine care Touch screen maintenanceShipping preparation Index

Related manuals

Manual 24 pages 33.22 Kb

Manual 115 pages 52.59 Kb