HP 2000 Base Model manual

Page 21

5.Remove the two screws next to the USB port. The screws are needed to install the USB module.

6.Slide the screw hole cover plate on the module back (1) and insert the USB connector on the module into the USB port (2).

Installing optional HP integrated USB peripheral modules 15

Image 21

Contents Hardware Reference Guide Product notice About This Book Iv About This Book Table of contents Preventing electrostatic damage Grounding methods Standard features Product overviewProduct Models Page Rear components Connecting a serial device Tools needed Hardware upgradesPage Unfolding the stand Adjusting the tilt angleRouting cables to external devices Page Replacing the power supply Page Page Installing optional HP integrated USB peripheral modules Page Page Page DDR3-SDRAM Sodimm Installing memoryRemove the front panel. See Removing the front panel on Removing the front panel Page Replacing the front panel Page Replacing the hard drive Page Page Replacing the battery Remove the front panel. See Removing the front panel on Securing the RP2 to a counter top Cable lock Installing an external security lockPadlock Configuring the software Configuring the MSRTouch screen calibration Configuring powered serial ports Table A-1Diagnostic Front Panel LEDs and Audible Codes TroubleshootingAppendix a Troubleshooting Activity Beeps Possible Cause Electrostatic discharge Preventing electrostatic damageGrounding methods Computer operating guidelines and routine care Touch screen maintenanceShipping preparation Index

Related manuals

Manual 24 pages 33.22 Kb

Manual 115 pages 52.59 Kb