HP 2000 Base Model manual

Page 20

3.Pry off the bottom part of the USB cover plate (1) and then pull the cover plate off the unit (2).

4.Pull the plug that is inserted in the USB port out of the port. NOTE: Some models do not have plugs in the USB ports.

14 Chapter 2 Hardware upgrades

Image 20

Contents Hardware Reference Guide Product notice About This Book Iv About This Book Table of contents Preventing electrostatic damage Grounding methods Product Models Standard featuresProduct overview Page Rear components Connecting a serial device Hardware upgrades Tools neededPage Adjusting the tilt angle Unfolding the standRouting cables to external devices Page Replacing the power supply Page Page Installing optional HP integrated USB peripheral modules Page Page Page Installing memory DDR3-SDRAM SodimmRemove the front panel. See Removing the front panel on Removing the front panel Page Replacing the front panel Page Replacing the hard drive Page Page Replacing the battery Remove the front panel. See Removing the front panel on Securing the RP2 to a counter top Installing an external security lock Cable lockPadlock Touch screen calibration Configuring the softwareConfiguring the MSR Configuring powered serial ports Troubleshooting Table A-1Diagnostic Front Panel LEDs and Audible CodesAppendix a Troubleshooting Activity Beeps Possible Cause Grounding methods Electrostatic dischargePreventing electrostatic damage Touch screen maintenance Computer operating guidelines and routine careShipping preparation Index

Related manuals

Manual 24 pages 33.22 Kb

Manual 115 pages 52.59 Kb