HP 2000 Base Model manual

Page 18

10.Replace the side panels on the base. To do so, insert the tabs at the bottom edge of the panel onto the base (1) then rotate the top edge of the panel onto the base (2) so that it snaps in place.

11.Connect the power cord to an electrical outlet.

12 Chapter 2 Hardware upgrades

Image 18

Contents Hardware Reference Guide Product notice About This Book Iv About This Book Table of contents Preventing electrostatic damage Grounding methods Standard features Product overviewProduct Models Page Rear components Connecting a serial device Hardware upgrades Tools neededPage Adjusting the tilt angle Unfolding the standRouting cables to external devices Page Replacing the power supply Page Page Installing optional HP integrated USB peripheral modules Page Page Page Installing memory DDR3-SDRAM SodimmRemove the front panel. See Removing the front panel on Removing the front panel Page Replacing the front panel Page Replacing the hard drive Page Page Replacing the battery Remove the front panel. See Removing the front panel on Securing the RP2 to a counter top Installing an external security lock Cable lockPadlock Configuring the software Configuring the MSRTouch screen calibration Configuring powered serial ports Troubleshooting Table A-1Diagnostic Front Panel LEDs and Audible CodesAppendix a Troubleshooting Activity Beeps Possible Cause Electrostatic discharge Preventing electrostatic damageGrounding methods Touch screen maintenance Computer operating guidelines and routine careShipping preparation Index

Related manuals

Manual 24 pages 33.22 Kb

Manual 115 pages 52.59 Kb