Installing optional HP integrated USB peripheral modules

Installing optional HP integrated USB peripheral modules

Only HP approved integrated USB peripheral modules will work with the RP2, such as the HP webcam, fingerprint reader, MSR (single-head and dual head), 2 x 20 LCD (complex and non- complex) customer facing display, 7" LCD customer facing display, and 2D imager scanner

NOTE: Do not install an HP webcam, 2 x 20 LCD (complex and non-complex) customer facing

display, or a 7" LCD customer facing display on the sides of the display head. These three peripheral modules must be installed on top of the display head for proper video orientation.

NOTE: Only install HP approved USB peripherals designed for these USB ports. The USB ports do not support optical drives or hard drives.

The procedure for installing an HP integrated USB peripheral module is the same for all modules. To install an HP USB peripheral module, follow the steps below.

1.Turn off the computer properly through the operating system, then turn off any external devices.

2.Disconnect the power cord from the power outlet.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to the internal components of the computer.

Installing optional HP integrated USB peripheral modules 13