Installing internal USB flash drives
There are two USB flash drive ports on the system board.
To install a USB flash drive:
1.Remove/disengage any security devices that prohibit opening the computer.
2.Remove all removable media, such as USB flash drives, from the computer.
3.Turn off the computer properly through the operating system, and then turn off any external devices.
4.Disconnect the power cord from the power outlet, and disconnect any external devices.
5.Remove the computer from the stand and lay the computer down with the right side up.
6.Remove the computer access panel and back I/O panel. See Removing and replacing the access panel on page 10.
WARNING! To reduce risk of personal injury from hot surfaces, allow the internal system components to cool before you touch them.
7.If the computer is an HP t620 PLUS Thin Client, push the fan assembly latch (1) toward the front of the computer and rotate the assembly (2) up and out of the way.
8.Locate the USB flash drive ports on the system board.
14 Chapter 2 Hardware changes