HP ZBook 14 Mobile manual

Page 35

2.Using four 15 mm screws included in the mounting device kit, attach one side of the HP Quick Release to the thin client as shown in the following illustration.

3.Using four screws included in the mounting device kit, attach the other side of the HP Quick Release to the device to which you will mount the thin client. Make sure the release lever points upward.

Mounting the thin client 29

Image 35

Contents Hardware Reference Guide Hardware Reference Guide About This Book Iv About This Book Table of contents Preventing electrostatic damage Grounding methods Standard features Product featuresFront panel components Rear panel components Ctrl key Using the keyboardAdditional function keys Special mouse functionsWindows Logo Key Serial number location Hardware changes Connecting the power cord Attaching the stand Removing the access panel Removing and replacing the access panelPage Replacing the access panel Page Installing internal USB flash drives Page DDR3L-SDRAM SODIMMs Installing additional memorySODIMMs Populating Sodimm sockets Installing SODIMMsPage Page Page Page Page Installing a half-height PCI-Express 2.0 card Page Page Hood sensor SecurityCable lock Mounting the thin client Page Page Supported mounting options Dimensions SpecificationsPower Output maximum Removing and replacing the battery Page Page Page Routine thin client care Thin client operationSupported orientations Appendix C Thin client operation Non-supported orientation Grounding methods Electrostatic dischargePreventing electrostatic damage Removing the solid state drive flash memory Important service repair informationShipping information Shipping preparationPage Page Keyboard IndexSSD

Related manuals

Manual 106 pages 35.98 Kb