HP ZBook 14 Mobile manual

Page 26

12.To remove a SODIMM, press outward on the two latches (1) on each side of the SODIMM, rotate the SODIMM up (2), and then pull the SODIMM out of the socket (3).

13.Slide the new SODIMM (1) into the socket at approximately a 30° angle, and then press the SODIMM into the socket (2) so that the latches lock it in place.

NOTE: A memory module can be installed in only one way. Match the notch on the module with the tab on the memory socket.

20 Chapter 2 Hardware changes

Image 26

Contents Hardware Reference Guide Hardware Reference Guide About This Book Iv About This Book Table of contents Preventing electrostatic damage Grounding methods Product features Standard featuresFront panel components Rear panel components Using the keyboard Ctrl keyAdditional function keys Special mouse functionsWindows Logo Key Serial number location Hardware changes Connecting the power cord Attaching the stand Removing and replacing the access panel Removing the access panelPage Replacing the access panel Page Installing internal USB flash drives Page DDR3L-SDRAM SODIMMs Installing additional memorySODIMMs Installing SODIMMs Populating Sodimm socketsPage Page Page Page Page Installing a half-height PCI-Express 2.0 card Page Page Security Hood sensorCable lock Mounting the thin client Page Page Supported mounting options Specifications DimensionsPower Output maximum Removing and replacing the battery Page Page Page Thin client operation Routine thin client careSupported orientations Appendix C Thin client operation Non-supported orientation Grounding methods Electrostatic dischargePreventing electrostatic damage Shipping preparation Important service repair informationShipping information Removing the solid state drive flash memoryPage Page Index KeyboardSSD

Related manuals

Manual 106 pages 35.98 Kb