Reverse this procedure to reassemble and install the hard drive.
Display assembly subcomponents
NOTE: The display assembly is spared at the subcomponent level only. For more display assembly spare part information, see the individual removal subsections.
To remove the display assembly and access the display assembly subcomponents, follow these steps:
1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect the power from the computer by unplugging the power cord from the computer.
3.Disconnect all external devices from the computer.
4.Remove the bottom cover (see Bottom cover on page 33).
5.Disconnect the battery cable from the system board (see Battery on page 35).
Remove the display assembly:
1.Open the computer and rest it on its keyboard.
2.Disconnect the display panel touch cable (1) from the system board.
3.Detach the display panel touch cable (2) from the system board. (The display panel touch cable is attached to the system board with
4.Disconnect the display panel cable (3) from the system board.
5.Release the display panel cable (4) from the retention clip (5) built into the right display hinge.
Component replacement procedures | 45 |